• 
  New Members - please post your introductions here

  by petabyte

  As this is a brand new forum, I thought I'd open up a thread to encourage new members to introduce themselves a bit.. now hey.. let's not get too personal.. ok ?
  
  And if you wouldn't mind to keep this thread \"clean\" let's try to keep the the chitchat (i.e. even the welcome to the board replies) to a minimum or this thread may get to 100 pages fast
  
  So I'll start things off :
  
  My name is petabyte and I'm a forum junkie. :oops: I've been off the wagon for a number of years and countless times I've tried to stop but it's useless.....

  • Channel: Announcements & Related News

  10-09-2003, 02:21 PM
• 
  ideapad miix 510-12isk bios

  by tugrul63

  ı need ideapad miix 510-12isk bios dump. thanks

  • Channel: BIOS Requests ONLY!

  01-13-2018, 04:34 AM
• 
  Samsung TV mu6179 with Mainboard BN41-02568B wont save configuration.

  by fixitforfree

  I have two Boards BN41-02568B for a UE55MU6179 of which one does produce a good picture (Board A) but can not save its configuration (even a factory reset will not work) and one board which produces a distorted picture (Board B). Learning from here the IC1604 saves the configuration of such a TV.
  
  Before replacing the IC1604 from Board B to Board A - would that actually solve the problem from Board A not being able to store its configuration or could there be something else wrong with writing to the flashrom? Is it even the right chip to replace or should I look out for a different...

  • Channel: Troubleshooting TVs and Video Sources

  07-21-2025, 09:07 AM
• 
  Again, needs cleaning, thanks.Yoga 7 14IAL7

  by EthanMai

  Yoga 7 14IAL7 - Type 82QE
  
  SN: PF3SSFEG
  
  NM-E191
  Again, needs cleaning, thanks...

  • Channel: BIOS Requests ONLY!

  08-09-2024, 04:03 PM
• 
  Need help to identify and to locate a 0.33 ohms fusible resistor for power supply

  by gica69

  I have a quad charger that is split into 4 separate sections and one section doesn’t charge anymore. I have located what I think is a thermistor and on the shrink tube it says 125 degrees C. I cut the shrink tube and it's a 33 ohms resistor. It measures a little less than 1/2 inch in length. I am including pictures of it. Please help me identify it. So, it should test at 0.4ohms and probably go up in resistance with the rise in temp. On the board it clearly says R for resistor. But it has to be a special one.
  Resistor shows orange range silver gold and green lines.
  Thanks in adv...

  

  4 Photos

  • Channel: General Electronics Technical Discussion

  07-21-2025, 09:49 PM

There are no results that meet this criteria.