Dell n5010 can be converted from graphic version to non graphic

[raajkumar]

Re: Dell n5010 can be converted from graphic version to non graphic

No it is not. You have to follow 4-photo method to get it working

But i couldn't find any components like those 4 photos show on Dell inspiron N5110.

[reddemonic]

Re: Dell n5010 can be converted from graphic version to non graphic

damn, would be nice if we can do this on macbooks.

[haritvr]

Re: Dell n5010 can be converted from graphic version to non graphic

U want to remove the GPU chip then display I'll ok

[raajkumar]

Re: Dell n5010 can be converted from graphic version to non graphic

U want to remove the GPU chip then display I'll ok

Do you think about Dell inspiron N5110 ?

[haritvr]

Re: Dell n5010 can be converted from graphic version to non graphic

Yes sir GPU and that sup ic and coil and cap and fet these are removed then DSP I'll ok

[imranromi]

Re: Dell n5010 can be converted from graphic version to non graphic

yes i success convert to graphic to non graphic dell n5010. No need to remove graphic chip.
last time i convert to non grahic little mistake display white but no data today i success.

[haritvr]

Re: Dell n5010 can be converted from graphic version to non graphic

Dear sir Some component not mentioned on the board for exm graphics ram ic and some one smd component also missed so

[raajkumar]

Re: Dell n5010 can be converted from graphic version to non graphic

yes i success convert to graphic to non graphic dell n5010. No need to remove graphic chip.
last time i convert to non grahic little mistake display white but no data today i success.

How did you success it. Can you explain it ?

[vickey_vip]

Re: Dell n5010 can be converted from graphic version to non graphic

I successful do it on my motherboard which part no is following
09909-1
DG15
48.4HH01.011

DO THE FOLLOWING CHANGES WHICH I POSTING IN IMAGES

FOR THOSE WHO HAVE WHITE DISPLAY FOLLOW INSTRUCTION WHICH SHOWN IN PICTURE
if any one have issue msg me

[oxonater]

Re: Dell n5010 can be converted from graphic version to non graphic

Hi guys sorry to ask a noob question but looking for the 2.2k resistor in the 4 picture method but don't a[[ear to be able to locate please help!!!!!!1
many thanks in advance

[spidey]

Re: Dell n5010 can be converted from graphic version to non graphic

For the guys who couldn't be succesfull of doing this conversion by following the guide, at the 8th pic. of vickey_vip's message, marked with "D point" is the missing element. remove q5702 from its place which is near speaker-mic jacks. Solder it to D point.

[oxonater]

Re: Dell n5010 can be converted from graphic version to non graphic

Hi thank you for your reply

I have since found this missing part by searching the net for a solution to my problem as there is various different guides.

The problem I have at the moment is my N5010 is beeping at me with a blank screen 3 beeps to be precise. I press the power button a few times and a white screen is present then press power button again and it returns to blank. Noticed the power button does not actually turn off when pressed it kind of blinks only way to switch off is remove power supply.

The only difference I have done to the previous guide is remove the IC near Northbridge chip (still has a cap were a 0 ohm resistor is on some boards).

Also coil and Mosfet and another IC left side of the GPU which is also removed.


3 beeps are noted as being related to the following :-

◾chipset Error (North and South bridge error, DMA/IMR/Timer error)
◾Time-Of-Day Clock test failure
◾Gate A20 failure
◾Super I/O chip failure
◾Keyboard controller test failure


Thing beeps regardless if it has RAM,CPU, or nothing at all, confused I AM.

Any help on this issue would be greatly appreciated many thanks in advance OXY

[oxonater]

Re: Dell n5010 can be converted from graphic version to non graphic

Hi yes it did have that gpu which has since been removed.
Just wondered my version board has the 4 VRAM chips, I have seen in earlier posts about placing 2 12p 50v resonator smd caps. Please if someone could clarify if these are needed.

There is lots of different guides out there to pinpoint one that is specific to my board Rev is difficult and somewhat confusing.

Many thanks for replies

[ktmmotocross]

Re: Dell n5010 can be converted from graphic version to non graphic

i see more boards with bad NB balls than with GPU balls/ATI/. so u must double chceck, what ic have bad connection.

more when u have NB and GPU close

[ahmed33essawy]

Re: Dell n5010 can be converted from graphic version to non graphic

is there anything new ?

hi ibrahim there some note
1- there are resistor rn2002 2700 ohm code (272) if u didnt find this use 4700 ohm code of it(472)
2- use crystal 25x under it 2 capstor under them and betwen them use res 1mega code of it (01c) or(105) or (1004)
i do it and work great
and follow the chines pdf
good luck

[GULSHAN SARWA]

Re: Dell n5010 can be converted from graphic version to non graphic

i successful do it on my motherboard which part no is following
09909-1
dg15
48.4hh01.011

do the following changes which i posting in images

for those who have white display follow instruction which shown in picture
if any one have issue msg me

still problem are same ,,, white display pls reply

[vickey_vip]

Re: Dell n5010 can be converted from graphic version to non graphic

still problem are same ,,, white display pls reply

Anyone who get white display or Blank screen check below two solution if you get white display only backlight then remove any cap under Intel VGA which is placed under 1 mega ohm resistor and if you get black display with backlight mean no data or character showing on screen then you must check R2603 (0 Ohms resistance) is there you put or not. If you forget to add this reg. Then you not get any data on screen I am attaching picture of that location. Today I successfully convert another motherboard of dell using my previous posting image method

[barkinaksoy]

Re: Dell n5010 can be converted from graphic version to non graphic

I successful do it on my motherboard which part no is following
09909-1
DG15
48.4HH01.011

DO THE FOLLOWING CHANGES WHICH I POSTING IN IMAGES

FOR THOSE WHO HAVE WHITE DISPLAY FOLLOW INSTRUCTION WHICH SHOWN IN PICTURE
if any one have issue msg me

Hello
I am tring this method but i think there is missed page. Could you help me please ..

[vickey_vip]

Re: Dell n5010 can be converted from graphic version to non graphic

Hello
I am tring this method but i think there is missed page. Could you help me please ..

Yes bro tell me what problem you facing

[kitsaras]

Re: Dell n5010 can be converted from graphic version to non graphic

Hi. I follow all the steps from vickey_vip but when i press the power button the screen flashes like is go to open and then get's again black.

Note: I have removed the BGA chip and all the rams if there is any problem?

Regards.