LG 65uf7690-uh picture problems

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • nwelec
    Senior Member
    • Dec 2014
    • 61
    • usa
    #1

    LG 65uf7690-uh picture problems

    When both sides of the Tcon are connected the TV picture looks like picture one and according to the person who owns the tv originally the problem was on top. If I disconnect the left cable to the Tcon then it looks like picture two and if I disconnect right side it looks like picture three. Now with either side disconnected the picture that is showing will start to fade. I am pretty sure bad panel but I have not ruled out the Tcon and am asking for advice. There are no side tabs so tab removal is out of the question.
    Attached Files
    Tags: None
    • budm
      Badcaps Legend
      • Feb 2010
      • 40746
      • USA
      #2
      Re: LG 65uf7690-uh picture problems

      Panel problem, since the tab bonding boards are on the bottom edge of the panel, you should inspect them, also inspect the side tabs (Gate drive) if it has any.
      Last edited by budm; 04-23-2019, 07:08 PM.
      Never stop learning
      Basic LCD TV and Monitor troubleshooting guides.
      http://www.badcaps.net/forum/showthr...956#post305956

      Voltage Regulator (LDO) testing:
      http://www.badcaps.net/forum/showthr...999#post300999

      Inverter testing using old CFL:
      http://www.badcaps.net/forum/showthr...er+testing+cfl

      Tear down pictures : Hit the ">" Show Albums and stories" on the left side
      http://s807.photobucket.com/user/budm/library/

      TV Factory reset codes listing:
      http://www.badcaps.net/forum/showthread.php?t=24809

        Comment

        • nomoresonys
          Badcaps Legend
          • Jan 2013
          • 12206
          • U.S.
          #3
          Re: LG 65uf7690-uh picture problems

          Looking like panel issue, the cutoff tape method might get you a good image.

            Comment

            • nwelec
              Senior Member
              • Dec 2014
              • 61
              • usa
              #4
              Re: LG 65uf7690-uh picture problems

              Thanks for the quick replies, sorry I did not answer earlier I never got a notification that it was answered.

                Comment

                • Wilderone
                  Senior Member
                  • May 2018
                  • 76
                  • Australia
                  #5
                  Re: LG 65uf7690-uh picture problems

                  This is the Mainboard, I did one recently.
                  Common fault for the UF series.
                  Notice the menus are still okay.
                  There are revised boards available from LG suppliers.

                    Comment

                    • nwelec
                      Senior Member
                      • Dec 2014
                      • 61
                      • usa
                      #6
                      Re: LG 65uf7690-uh picture problems

                      The difference is my menu is not ok so that usually is the panel.

                        Comment

                        • budwich
                          Badcaps Legend
                          • Jul 2015
                          • 3097
                          • Canada
                          #7
                          Re: LG 65uf7690-uh picture problems

                          as suggested, try the "tape cutoff" method (placing a bit of tape on the tcon cable to block certain pins) and see if you can get a proper picture.

                            Comment

                            • vinceroger69
                              Badcaps Legend
                              • Mar 2012
                              • 6714
                              • uk
                              #8
                              Re: LG 65uf7690-uh picture problems

                              This video maybe worth watching https://www.youtube.com/watch?v=j7vl7-vZEL8

                                Comment

                                • nwelec
                                  Senior Member
                                  • Dec 2014
                                  • 61
                                  • usa
                                  #9
                                  Re: LG 65uf7690-uh picture problems

                                  Thanks for the response but still does not fix the tv issue. No mater where I put the tape the video still has lines in it.

                                    Comment

                                    • nomoresonys
                                      Badcaps Legend
                                      • Jan 2013
                                      • 12206
                                      • U.S.
                                      #10
                                      Re: LG 65uf7690-uh picture problems

                                      Cut tape works on a lot of m, try turning down your backlights not brightness if possible, see if the double image clears up any.

                                        Comment

                                        • nwelec
                                          Senior Member
                                          • Dec 2014
                                          • 61
                                          • usa
                                          #11
                                          Re: LG 65uf7690-uh picture problems

                                          After playing with the panel I found that the right side connector if pushed on clears up the picture so I am going to play with it to see if maybe it is just some bad solder.

                                            Comment

                                            Previous template Next

                                            Related Topics

                                            Collapse
                                            • Fly_Among_Stars
                                              VIZIO E70-E3 Half picture with half TCON
                                              by Fly_Among_Stars
                                              Hi,
                                              I have a VIZIO E70-E3.
                                              Symptoms: Black screen, no picture, but LED backlights are working.
                                              I probed the power board and voltages are as listed on the board.
                                              Main board appears fine, too.
                                              I believe the problem is either a bad T-CON board, or connection to LCD, or bad LCD.
                                              There are two separate ribbon cables feeding the LCD.
                                              If both are connected, the screen is black.

                                              If only the ribbon cable that feeds the right side of the screen (when viewed from the front) is disconnected, the left side of the screen shows picture and...
                                              04-24-2023, 08:20 PM
                                            • howardc64
                                              A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
                                              by howardc64
                                              Problem

                                              This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
                                              08-04-2024, 10:36 PM
                                            • shelby5041
                                              Samsung LCD TV no picture backlight on no 12v at tcon
                                              by shelby5041
                                              hi
                                              i have a samsung lcd tv

                                              it powers on with sound and backlight but no picture

                                              all voltages from PS are good 12v 3.3v and 5v

                                              whats odd is that at the tcon i tested voltage across the fuse on the tcon and i get 0v

                                              i figured main board issue..so i ordered a used main board....when i put replacement main board in i still have same issue

                                              no 12v at the tcon fuse

                                              i disconnect the panel ribbon cables to rule out any panel issues and i still have no 12v at the tcon fuse

                                              the odds of having 2...
                                              10-08-2021, 08:21 AM
                                            • halen
                                              Hisense H55U7B vertical stripes
                                              by halen
                                              Hi all,

                                              I have Hisense H55U7B TV with no picture, only big vertical stripes. I did several tests and I'm not sure, where is problem.

                                              1. Connected tcon to 12V, white, red, green, blue, black picture visible in cycle on full LCD without error
                                              2. Connected only left side of LCD to tcon, big stripes
                                              3. Connected only right side of tcon, visible normal picture on the right. Working as expected.

                                              Where could be problem?

                                              Tcon RSAG7.820.7932/ROH
                                              Main board RSAG7.820.8698/ROH

                                              Jan
                                              06-18-2025, 03:58 AM
                                            • Vahalaru
                                              Visio E600i-B3 will not power on.
                                              by Vahalaru
                                              [B]Background[/B]
                                              I recently fixed our Samsung black screen of death by watching YouTube videos and reading through previous threads. Removed a few ceramic capacitors and fixed a short on the back side of the tcon board. So my father and law asked me if I could try to fix his visio. He said that it wouldn't power on. When he first brought it to me I plugged it in and there was a standby light. When I hit the power button the TV booted up and everything worked. I hit the power button again and then I saw what he ment. Since then I have not been able to get it to power on or have a standby...
                                              08-24-2021, 07:23 PM
                                            • Loading...
                                            • No more items.
                                            Working...