Re: Benq G2255 doesn't power on - amber power light when plugged in
Did you look at my pictures on post 39 that I clearly marked where GNDs are?
Again, look at the left side of R802, it is connected to GND.
C805 is also connected in parallel with R802, the right side of R802/C805 are connected to pin 7 of the IC, so I do not see how you can say that one end of R802 is connected to pin 4!
Your picture here https://www.badcaps.net/forum/attach...6&d=1515675227
Clearly show the reading of 0.09V at TWO PLACES, both if them are GNDs. I do not see any arrow pointing to pin 4 at all.
See my new pix that I have marked again.
It looks like I am getting wrong DATA from you.
Are you sure you count the IC pins correctly or may be we are not looking at the same pictures same board?
Did you look at my pictures on post 39 that I clearly marked where GNDs are?
Again, look at the left side of R802, it is connected to GND.
C805 is also connected in parallel with R802, the right side of R802/C805 are connected to pin 7 of the IC, so I do not see how you can say that one end of R802 is connected to pin 4!
Your picture here https://www.badcaps.net/forum/attach...6&d=1515675227
Clearly show the reading of 0.09V at TWO PLACES, both if them are GNDs. I do not see any arrow pointing to pin 4 at all.
See my new pix that I have marked again.
It looks like I am getting wrong DATA from you.
Are you sure you count the IC pins correctly or may be we are not looking at the same pictures same board?
Comment