It may be very dark. In a pitch black room, no glow whatsoever?
If so, need a pic of Y-main and X-main to check -Vsc, Ve.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Does the LED blink approx once a second? Did you remove the LVDS cable?
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Yes. That's the cable. X-main and Y-main both plugged in? How did you get screen to glow before? Really odd...
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Well I have changed all the caps and I'm getting the right voltage to the main board and I think I may of caught a compasitor on the av board when I was checking it because it did power up just with no pic
^What about that. No glow? Just stopped clicking? I thought you meant glow
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
No there was nothing on the sceen but the start up tune was there then I touched something on the A board by mistake then all I got was clicking over and over
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Try removing buffers and checking VSCH again. Without schematics, repair of Y-Main board may be difficult, so replacement might be only option.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Leave ribbons in if you want (doesn't matter), just remove all connectors from Y-main.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
right with everything off ribbons bottom small lead to the lower board (not sure of name ) and the ribbon from the the control board i get -100v from the red thingy lol and -22.2 from the black connector
For the black connector, I want you to test BETWEEN the two highlighted pins with buffers both installed and removed, expecting about 130V.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Comment