joel warren
Member
Last Activity: 04-24-2025, 05:30 PM
Joined: 01-27-2025
Location: Luxemburg
-
No caps were testing bad, so I have no way of knowing which cap to remove. -
Yes. Screen buffer board issueLeave a comment:
-
thx. guess i'll be throwing it in the garbage.Leave a comment:
-
I installed the jumper again, removed the left side of the U ribbon cable and I do get a picture on 3/4 of the screenLeave a comment:
-
Leave a comment:
-
what ohm setting should my meter be on to test the pins? I have 2000k, 200k, 20k, 2000, 20Leave a comment:
-
I'm not sure I understand. would like me to measure between the chassis and the ckv? If so, can you please point out in one of my pictures where the CKV lines are on the board?Leave a comment:
-
yes. if I disconnect the left side of the U ribbon I get the same result...Leave a comment:
-
I blocked all 8 CKV lines on the U ribbon cable and the tv no longer clicks, the backlight stays on, but there is no picture....Leave a comment:
-
which one is the resistor that I should be checking?Leave a comment:
-
TVs diodes…Leave a comment:
-
Ok. Have any extras????...Leave a comment:
-
I will try the tape method on CKV 1, 2, 3, 4, 5, 6, 7, 8Leave a comment:
-
zero readings on anything.Leave a comment:
-
the 1/4 of the tv with the "no picture" note is the one that has no picture and also the side with the buffer board that I was testing the tvs diodes on. I tested the diodes on the opposite side of the tv and have the same results.Leave a comment:
-
Leave a comment:
-
I am getting zero readings in diode mode besides continuity between pins 2&5 on each tvs diodeLeave a comment:
-
Leave a comment:
-
Leave a comment:
-
Leave a comment:
No activity results to display
Leave a comment: