-
-
Re: Eeprom dump thread!
not probleme brathre dani502017Comment
-
Re: Eeprom dump thread!
ThanksComment
-
Re: Eeprom dump thread!
Thank you for posting . is there anyone here from South AfricaComment
-
Re: Eeprom dump thread!
Thank you alhootalhootComment
-
Re: Eeprom dump thread!
anyone have a good eeprom dump for a RCA 40GE01M3393LNA35-A1 Main Board for LED40G45RQComment
-
Re: Eeprom dump thread!
ok tanksComment
-
Re: Eeprom dump thread!
v236h1-le4+rev.c1Comment
-
Re: Eeprom dump thread!
anyone plz help...i need bios for moserbaer lcd tv LTH26845...25L16 icLast edited by madhu; 02-15-2019, 10:50 PM.Comment
-
Re: Eeprom dump thread!
thank you so muchComment
-
Re: Eeprom dump thread!
Looking for bin for Haier LE19B3320 it comes in several flavours another being the Proscan PLED1960A.
Mainboard stamped with MSAV3226-ZC01-01Comment
-
Re: Eeprom dump thread!
Thanks Unspun01,
I'm not sure it's the same, but it is worth a shot too see if the unit will at least power on.Comment
-
Re: Eeprom dump thread!
TP.MS3393.P85 eeprom dump RCA RLDED3916AComment
-
Hello, This might be a long shot, but I'm looking for an EEPROM dump for a HP Photosmart C4280 All-in-one printer.
The printer seems to be in cartridge alignment mode. Sometimes it print the alignment page and then hangs during the scanning step, sometimes it hangs during the printing process and sometimes it hangs during the boot process. If I let it idle for a while then it flashes the back-light of the top screen and there's a letter E. Bottom screen is asking me to restart it to no avail. I have to remove the power cable from the printer for a couple of minutes to make it work...02-17-2022, 09:09 PM -
Good day to every one,
I have AVR 171 the IC1504 (24C32) eeprom is corrupted not able to read.
Does anybody have an eeprom dump file? I really appreciate any help.
Thanks in advance.07-01-2024, 09:04 PM -
P14s Gen 2
HT4B0/HP4B0/HT5B1/HT4B2
NM-D352 Rev 1.0
sn PF-35P15W
Requesting thunderbolt dump
also attached is the tbt dump. I extracted the bin from the cap file and modified it, not sure if it's correct. also didnt work.... -
Hi
I was working all day on a 42" with no backlight = Driver is bad . LED Tester. Image exists
As I was reassembling, I discovered faults on the screen ( used the LED Tester to power the strips).
Right distribution board, 2 Flexs, near them:
The one near the center has 1" line on screen. Pressing on the board-side or Panel side of the Flex bonding place results in some change, I sensed heating one time, but main fault line remains
The other, pressing on the Panel to the Chassey and the lines disappears 99.99%
I... -
Comment