Re: My recapped VP6 is acting weird.
Watch out for that big red arrow - it looks sharp
Watch out for that big red arrow - it looks sharp
-
-
Re: My recapped VP6 is acting weird.
That Thermaltake 430W PSU does look a little on the cheap side, but better than a L&C. Teapos are fine in a PSU, and I haven't seen a CapXon cap fail yet in a PSU.
That will do fine powering the VP6.My gaming PC:
AMD Phenom II X6 1100T Black Edition 3.3GHz Six-Core CPU (Socket AM3)
ASUS M4A77TD AMD 770 AM3 Motherboard
PowerColor AMD Radeon RX 480 8GB GDDR5 PCI-Express x16 3.0 Graphics Card
G.SKILL Value Series 16GB DDR3-1333 RAM (4x4GB dual channel)
TOSHIBA DT01ACA200 2TB 3.5" SATA HDD (x2)
WD Caviar Green WD20EARX 2TB 3.5" SATA HDD
ASUS Xonar DG 5.1 Channel PCI sound card
Antec HCG-750M 750W ATX12V v2.32 80 PLUS BRONZE Power Supply
Antec Three Hundred Mid-Tower Case
Microsoft Windows 10 Pro 64-bit
Microsoft Windows 7 Ultimate SP1 64-bitComment
-
Re: My recapped VP6 is acting weird.
New supply is installed and the voltage numbers look almost exactly like the Antec power supply's numbers.
But no wierd noise.
The "2.5v is too higher" message still comes up when enabled. It's obvious that it's not the fault of the power supply.
Here's a question: When you use a new style supply to power a slightly older board could it cause an unexpected voltage levels? I noticed that the ATX standard developed to the point where a certain wire is no longer required (it was dropped from the ATX spec).
.
.
.
.
.
......someone forgot to pack that little red arrow with my new power supply.
.Comment
-
Re: My recapped VP6 is acting weird.
Try this site http://www.computergate.com/products...rodcd=BCFDPCUM
They carry the AMD K7 CPU cooler for $7.95 for two. Similar to the one you're showing.Comment
-
Re: My recapped VP6 is acting weird.
I've seen some new power supplies missing IIRC the white +5VSB wire on the ATX connector. I have four ATX power supplies like that, and the missing 5VSB wire won't hurt the motherboard at all. They didn't damage my old trusty AOpen AX6BC Slot 1 motherboard (that board came stock with United Chemi-Con caps, wow for a board made in 1999!Originally posted by gastorgrab ).
My gaming PC:
AMD Phenom II X6 1100T Black Edition 3.3GHz Six-Core CPU (Socket AM3)
ASUS M4A77TD AMD 770 AM3 Motherboard
PowerColor AMD Radeon RX 480 8GB GDDR5 PCI-Express x16 3.0 Graphics Card
G.SKILL Value Series 16GB DDR3-1333 RAM (4x4GB dual channel)
TOSHIBA DT01ACA200 2TB 3.5" SATA HDD (x2)
WD Caviar Green WD20EARX 2TB 3.5" SATA HDD
ASUS Xonar DG 5.1 Channel PCI sound card
Antec HCG-750M 750W ATX12V v2.32 80 PLUS BRONZE Power Supply
Antec Three Hundred Mid-Tower Case
Microsoft Windows 10 Pro 64-bit
Microsoft Windows 7 Ultimate SP1 64-bitComment
-
Re: My recapped VP6 is acting weird.
i put the old via monitor on a customers box today and got the same error including the engrish.
freshly recapped vp6 with tc's modded bios.
its a non issue.Comment
-
Re: My recapped VP6 is acting weird.
Those CPU coolers I mentioned from computergate are $7.95 each or $7.75 each for two or more. They have to be better than the stock Intel heatsinks with the green clips. And I agree, the VIA monitor abnormal voltage warning seems irrelevant and/or wrong.Comment
-
Re: My recapped VP6 is acting weird.
Is 2.5V to do with the RAM (VDIMM)?Comment
-
Re: My recapped VP6 is acting weird.
Actually, not that wow. Because back in the late 1990s, motherboards were more likely to use Rubycons.Originally posted by Newbie2They didn't damage my old trusty AOpen AX6BC Slot 1 motherboard (that board came stock with United Chemi-Con caps, wow for a board made in 1999! ).
And United Chemi cons probably were used more.Last edited by RJARRRPCGP; 01-16-2008, 07:44 AM.ASRock B550 PG Velocita
Ryzen 9 "Vermeer" 5900X
32 GB G.Skill RipJaws V F4-3200C16D-32GVR
Arc A770 16 GB
eVGA Supernova G3 750W
Western Digital Black SN850 1TB NVMe SSD
Alienware AW3423DWF OLED
"¡Me encanta "Me Encanta o Enlistarlo con Hilary Farr!" -Mí mismo
"There's nothing more unattractive than a chick smoking a cigarette" -Topcat
"Today's lesson in pissivity comes in the form of a ziplock baggie full of GPU extension brackets & hardware that for the last ~3 years have been on my bench, always in my way, getting moved around constantly....and yesterday I found myself in need of them....and the bastards are now nowhere to be found! Motherfracker!!" -Topcat
"did I see a chair fly? I think I did! Time for popcorn!" -ratdude747Comment
-
Re: My recapped VP6 is acting weird.
Same thing in ubuntu;
.Comment
-
Re: My recapped VP6 is acting weird.
No.Originally posted by dan8139
On VP6 RAM is 3.3v
2.5v (if it's even used) is most likely for some part of the chipset.
Can't be sure.
Unlike Intel's chipsets, diagrams of VIA chipsets aren't so easy to find.
.Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
Comment
-
Re: My recapped VP6 is acting weird.
The white wire is -5V, not 5Vsb (that's purple).Originally posted by Newbie2I've seen some new power supplies missing IIRC the white +5VSB wire on the ATX connector. I have four ATX power supplies like that, and the missing 5VSB wire won't hurt the motherboard at all. They didn't damage my old trusty AOpen AX6BC Slot 1 motherboard (that board came stock with United Chemi-Con caps, wow for a board made in 1999! ).
I think -5v is only used by some ISA cards (and apparently not many even of those). It's in the ISA pinout anyway.Comment
-
Re: My recapped VP6 is acting weird.
gdement's right.Originally posted by gdement
I've heard mention that some transitional MSI boards (about the time ISA slots were going away) used -5v on the board for something or other. My guess it that they didn't have an ISA slot but the board still had a legacy ISA BUS with some chip on it that needed -5v. (Maybe like a sound chip? - Not sure.)
.Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
Comment
-
Re: My recapped VP6 is acting weird.
Unless it's DDR, it isn't, AFAIK.Originally posted by dan8139ASRock B550 PG Velocita
Ryzen 9 "Vermeer" 5900X
32 GB G.Skill RipJaws V F4-3200C16D-32GVR
Arc A770 16 GB
eVGA Supernova G3 750W
Western Digital Black SN850 1TB NVMe SSD
Alienware AW3423DWF OLED
"¡Me encanta "Me Encanta o Enlistarlo con Hilary Farr!" -Mí mismo
"There's nothing more unattractive than a chick smoking a cigarette" -Topcat
"Today's lesson in pissivity comes in the form of a ziplock baggie full of GPU extension brackets & hardware that for the last ~3 years have been on my bench, always in my way, getting moved around constantly....and yesterday I found myself in need of them....and the bastards are now nowhere to be found! Motherfracker!!" -Topcat
"did I see a chair fly? I think I did! Time for popcorn!" -ratdude747Comment
-
Re: My recapped VP6 is acting weird.
I've never seen an Abit VP6 that uses DDR.
Have you?
.Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
Comment
-
Hi there,
I have an 820-3437 motherboard which does not show any signs of life when using an OEM charger. But the magsafe light comes up when connected using a fake charger. While using a fake charger, the fan spins for may be 10 seconds and stops. Then the loop continues. Almost every power rail is up, but with 0.2-0.3 V drop. But I do not get a display, but sometimes does. While powered using the fake charger, the CPU seems to be burning hot. I got display at about 3 instances with the fake charger.
But with the OEM charger, no signs of life.
Any... -
TF-FUSE Thin Film Surface Mount Fuses
FF Series (Very Fast Acting), 0603 Size
Features
● Very fast acting at 200% overload current levels
● Low DCR
● High inrush current withstanding capability
● Fiberglass enforced epoxy fuse body
● Copper termination with nickel and tin plating
● Halogen free, RoHS compliance and lead-free
Applications
● Notebook computers and tablets
● Digital cameras
● Memory cards
● Toys
● Bluetooth earphones
● Portable electronic devices...10-07-2024, 05:50 AM -
This started a few days ago and does this about every 8 hours
After it does this it goes back to normal no bad battery icon and no weird sounds and it goes to battery backup mode so I am not sure what is going on with this battery backup
The battery backup is about 3 or 4 years old
Dose anyone have any idea on how to troubleshoot this issue I have never had a battery backup do this kind-a thing before so I am not sure exactly how to troubleshoot it and where to start -
So, I have a really bizarre issue that I'm struggling to identify the cause of. Working on an 820-02020 board with some bizarre keyboard/input-source character mapping. My suspicion is a possible damaged SPI ROM (U1970), perhaps, but I'm really not sure in this case:
1. The issue is pretty weird, but when installing MacOS, I noticed my WiFi password did not work. I quickly realized the special characters (!@#$%^& etc) were not mapping correctly.
2. I noticed the keyboard layout/input-source is defaulting to JAPANESE every single time I restore the board. I am not... -
Hello guys,
I have recently aquired Lenovo Legion 7 16ithg6 NM-D721, with weird issue. From time to time it will POST fine, boot to windows and work without a single issue. After restart however, it will not post again and then it will not post at all.
After messing around with bios (reflashing it), removing ssd, wifi, battery, etc, none of helped, I checked 5v and 3.3 coils and to my surprise, multimeter showed both coils hovering around 4V for 5V coil and 2V for 3.3v coil.
Thermal camera did not showed anything hot, but I'm sure something is either going...
Comment