Re: bent neck CRT pins...
Good test. did you see the heater glow? Hard to tell by looking from the side of crt may try looking at the end of neck where the pins come out.
Next test for heater to cathode short while filament is hot ( powered up). Be sure that the cathode is not connected internally to the filament pins. Measure for heater voltage across the filament and cathode. Their should not be any voltage showing if good. Again no connection to the scope wiring for this test.
Originally posted by eccerr0r
View Post
Next test for heater to cathode short while filament is hot ( powered up). Be sure that the cathode is not connected internally to the filament pins. Measure for heater voltage across the filament and cathode. Their should not be any voltage showing if good. Again no connection to the scope wiring for this test.
Comment