Lg 37lf2510

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • gemadar
    New Member
    • Aug 2013
    • 6
    • uk

    #1

    Lg 37lf2510

    Hi, I have an issue with teh TCON board, i have had the AS15 chip replaced, but it still shows the same symptoms, guessing its the fuse, how do I find out what the fuse should be to replace?
    t370hw02 vc v402 37t04-c0m is the tcon board.

    thanks,

    mark.
  • diif
    Badcaps Legend
    • Feb 2014
    • 6978
    • England

    #2
    Re: Lg 37lf2510

    If the fuse has failed there would be no picture.
    The AS15 are sensitive to heat, perhaps when it was fitted there was too much heat.
    There are test points on the TCON that can be measured to confirm its a gamma issue.
    Last edited by diif; 07-08-2019, 07:59 AM.

    Comment

    • gemadar
      New Member
      • Aug 2013
      • 6
      • uk

      #3
      Re: Lg 37lf2510

      ahh ok, thanks for that, as I do have a picture, but it is washed out white, the picture is just about visible though, which is why i suspected the as15 chip, i sent it away to get it reaplced, but it came back the same issue.
      they are having another go with it at the moment, so maybe it is just that and they overheated it maybe????
      thankyou, ill see what happens when it comes back again, if it is still teh same i will post some pictures, to see if anuybody has any ideas?

      thanks,

      Comment

      • diif
        Badcaps Legend
        • Feb 2014
        • 6978
        • England

        #4
        Re: Lg 37lf2510

        I know I've had to redo a couple of AS15 and I have one fail due to the lack of the thermal pad.
        It's possible that there is something on the thin board between the TCON and panel that has an issue and is causing the image problem. Check for shorted ceramic capacitors.

        Comment

        • gemadar
          New Member
          • Aug 2013
          • 6
          • uk

          #5
          Re: Lg 37lf2510

          ok, board came back, flicked normal for a couple of seconds and then went straight back to a white screen with picture behind.
          checked the fuse, and fuse was fine, board was getting a steady 11.94 volts
          noted voltage on the test points i could find:-
          1-15.18
          2-14.93
          4-12.34
          6-10.71
          8-9.93
          10-8.00
          11-7.76
          12-6.78
          13-7.04
          15-4.85
          17-4.34
          19-2.767
          21-0.535
          22-300mv (basiclaly dont think this read a voltage, but not 100% sure as so low)

          anybody an ideas what could be the issue, or does anyone know a good place to get a replacement board, as ill quite happily get a replacement board if needs be.
          ill post a couple of pictures of board in a sec.

          thanks,

          mark.

          Comment

          • gemadar
            New Member
            • Aug 2013
            • 6
            • uk

            #6
            Re: Lg 37lf2510

            pictures of board attached.

            regards,

            mark.
            Attached Files

            Comment

            • budm
              Badcaps Legend
              • Feb 2010
              • 40746
              • USA

              #7
              Re: Lg 37lf2510

              "11-7.76
              12-6.78
              13-7.04"
              That is not right.
              Never stop learning
              Basic LCD TV and Monitor troubleshooting guides.
              http://www.badcaps.net/forum/showthr...956#post305956

              Voltage Regulator (LDO) testing:
              http://www.badcaps.net/forum/showthr...999#post300999

              Inverter testing using old CFL:
              http://www.badcaps.net/forum/showthr...er+testing+cfl

              Tear down pictures : Hit the ">" Show Albums and stories" on the left side
              http://s807.photobucket.com/user/budm/library/

              TV Factory reset codes listing:
              http://www.badcaps.net/forum/showthread.php?t=24809

              Comment

              • diif
                Badcaps Legend
                • Feb 2014
                • 6978
                • England

                #8
                Re: Lg 37lf2510

                Originally posted by gemadar
                ok, board came back, flicked normal for a couple of seconds and then went straight back to a white screen with picture behind.
                Was the thermal pad and shield fitted ?
                Who is it that has done the repair ?
                Last edited by diif; 07-11-2019, 02:32 PM.

                Comment

                • gemadar
                  New Member
                  • Aug 2013
                  • 6
                  • uk

                  #9
                  Re: Lg 37lf2510

                  Budm, yep didn't spot that, any ideas, is this still the chip?
                  Doug, tcon board was sent to have as15 chip replaced,
                  I removed from TV and refitted.
                  Mark.

                  Comment

                  • noledud
                    Badcaps Veteran
                    • Dec 2013
                    • 413
                    • united kingdom

                    #10
                    Re: Lg 37lf2510

                    I replace the AS15 chips myself but have also used TCON repair services on ebay - not sure if i can post the name but if you search TCON repair you should find it.

                    Comment

                    Related Topics

                    Collapse

                    • triplefour
                      Samsung UN55ES7003 has blown fuse on TCON and short to ground.
                      by triplefour
                      Samsung UN55ES7003
                      made house call.
                      red power led comes on, blinks twice, no display, no backlight, relay clicks, repeat.
                      psu has self test feature.
                      disconnected from mainboard.
                      determined PSU ok BL ok.
                      suspect mainboard.
                      disconnecting tcon has no change on operation.
                      markings on mainboard:

                      BN97-06531P 0151
                      BN94-06123R

                      found and ordered replacement on ebay https://www.ebay.com/itm/394077328633
                      for 54$

                      second house call:
                      with replacement mainboard, tv turns on, has sound,...
                      07-13-2022, 03:53 PM
                    • x_orange90_x
                      TCL 50S535 bad tcon or panel issue?
                      by x_orange90_x
                      Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
                      03-29-2025, 11:02 PM
                    • corrize
                      A funny fuse story – Lumix LX100 II
                      by corrize
                      Hello, I disassembled this dead camera, and found this WTF… Two fuses soldered one above the other !
                      I was pretty sure nobody touched it before, but that can't be from factory. There is flux, and capacitor is probably missing.
                      The other weird thing : the fuses are « G » fuse : (0.75A – 8V), seems very low. The original fuse should be « O » : (32V 2,5A).
                      There is « O » mark beside. All fuses have the same mark letter on main board. So, I can deduce it's a « O » fuse.
                      And this correspond to the issus I saw : when I plug the battery, I measure the voltage dropping...
                      10-19-2023, 09:58 AM
                    • advant
                      Driving a Sharp TCON/panel with a universal main board
                      by advant
                      This thread is about trying to get an Universal Main Board to work with a Sharp TCON and panel.

                      I have a Sharp LC-46D85UN TV that has had a main board issue. Since this model is from 2009, I am not able to find an exact replacement of the main board. Instead, I decided to see if I can future proof this tv by getting a Universal Main Board (T53U21.2) from China to work with the Sharp TCON (CPWBX4291TPZA) and panel. The universal main board supports a 8 bit dual channel LVDS interface whereas the TCON requires a 10 bit dual channel LVDS input. I have modded the LVDS connector to match...
                      02-03-2020, 12:25 AM
                    • Michale32086
                      LG 60LN5400 Blows TCON Fuse
                      by Michale32086
                      I could have sworn I posted about this before, but I can't seem to find the post..

                      To whit..

                      I have a 60LN5400 that came in.. Backlights work fine.. No display..

                      Traced the problem to the TCON board.. Blown fuse..

                      Replaced the fuse.. Blows again.. Replaced the fuse again... This time it fries the marked part on the Main Video board...

                      Got a new Main Video Board.. Replaced the fuse on the TCON..

                      The fuse is fine and the backlights come on fine if I don't have the cellophane connectors from the TCON to the...
                      10-30-2019, 09:21 AM
                    • Loading...
                    • No more items.
                    Working...