actually with wave forum measurement ( oscilloscope ) easy to find which ch of LVDS cause this and narrow it. however the MB of Samy can be edit too. i don't know if OP has logged before service mode there are many value can be shown for LVDS setting also EEPEOM RESET .
I've got a main board coming this week, £21 delivered. Couldn't really say no at the price. Hopefully it will be here Friday. Fingers crossed that it resolves my issue.
The lines have changed recently moved down the screen. Does that rule out the cable?
please post photo on this new issue... did it happen with your original main board?
BTW : the ribbon cable from T-CON to panel. you had only from T-CON side check it... you need to do the same from panel side to clean and reset.. but be careful that they may being dry so easy the pad pin broken.
It's the same kind of lines but just lower down the screen. The new tcon board came with the 2 ribbons so changed them to. I've put the original main board back in so these moved lines are from that board. Should I just get a replacement cable? Only board left to change is the power board.
well theres another board but its bonded too the lcd panel people have had issues with bad capacitors on that board too i doubt its a power supply problem though.
well theres another board but its bonded too the lcd panel people have had issues with bad capacitors on that board too i doubt its a power supply problem though.
it could be noise from PWB.. or LVDS.. or also could be crazy panel too... LOL i am now more confused .. line going down, and now up etc.. repairing behind screen like gambling. so better to stop since i hate gambling .. sorry.
it could be noise from PWB.. or LVDS.. or also could be crazy panel too... LOL i am now more confused .. line going down, and now up etc.. repairing behind screen like gambling. so better to stop since i hate gambling .. sorry.
sorry just re read the thread i thought the lvds lead had been replaced but it hasnt it was the ribbon cables and didnt even think about noise from a psu supply causing this issue.
I will get l lvds cable when I know what spare cash I've got. I can of course sell all the bits I've bought as a job lot to make some money back.
i would suggest you don't buy any parts more.. sell back what did you bought ... and put the original parts and keep using it tell the fault became more to identical fault parts
Comment