Emerson lc407em1 Turns on screen only flashes, then off

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • proaudiosoft
    Senior Member
    • Apr 2012
    • 68
    • USA

    #21
    Re: Emerson lc407em1 Turns on screen only flashes, then off

    Originally posted by tom66
    If you get the FUNAI part number for this board (begins with BA9) I may be able to find a schematic, if you don't already have one.
    the part number is BA01P0F01 03 3

    Comment

    • proaudiosoft
      Senior Member
      • Apr 2012
      • 68
      • USA

      #22
      Re: Emerson lc407em1 Turns on screen only flashes, then off

      Ok, I believe I found the service manual:

      Comment

      • proaudiosoft
        Senior Member
        • Apr 2012
        • 68
        • USA

        #23
        Re: Emerson lc407em1 Turns on screen only flashes, then off

        I am curious weather the ccfl's or inverter might be the cause since the screen flickers on the off 1 time when powered on near the center. I should also note that the person I received this tv from said it was damaged in a lighning storm

        Comment

        • proaudiosoft
          Senior Member
          • Apr 2012
          • 68
          • USA

          #24
          Re: Emerson lc407em1 Turns on screen only flashes, then off

          bump

          Comment

          • proaudiosoft
            Senior Member
            • Apr 2012
            • 68
            • USA

            #25
            Re: Emerson lc407em1 Turns on screen only flashes, then off

            should the tv stay powered on with inverter disconnected?

            Comment

            • proaudiosoft
              Senior Member
              • Apr 2012
              • 68
              • USA

              #26
              Re: Emerson lc407em1 Turns on screen only flashes, then off

              Any input on what to check would be so appreciated

              Comment

              • proaudiosoft
                Senior Member
                • Apr 2012
                • 68
                • USA

                #27
                Re: Emerson lc407em1 Turns on screen only flashes, then off

                Originally posted by proaudiosoft
                Any input on what to check would be so appreciated
                bump

                Comment

                • proaudiosoft
                  Senior Member
                  • Apr 2012
                  • 68
                  • USA

                  #28
                  Re: Emerson lc407em1 Turns on screen only flashes, then off

                  been a long while. just pulled this tv out from the basement again. I would love to get it working. I do not seem to have 345v (yes i do, disregard this)***EDITED) that i am supposed to. tv powers on, blinks green 15 times (as before, still the same ), then powers off. Any help would be so appreciated.
                  Last edited by proaudiosoft; 01-22-2015, 05:16 AM.

                  Comment

                  • proaudiosoft
                    Senior Member
                    • Apr 2012
                    • 68
                    • USA

                    #29
                    Re: Emerson lc407em1 Turns on screen only flashes, then off

                    Ok, so i have resurrected this thread. I still have this tv, same problem, never fixed yet. All voltages seem to be good on the power supply, my previous comment of missing 345v was in error, its there still. A couple voltages seem to be a couple volts higher maybe, but they all seem to be present. I am tempted at this point to order a used mainboard off ebay and give it go. does anyone have any input on anything I might check before doing so? I would like to power this supply on with the mainboard disconnected, but this particular mainboard has 2 cables coming from the supply, and both seem to be necessary for powering on with backlight operating and such. Any advice or guidance greatly appreciated.

                    Comment

                    • proaudiosoft
                      Senior Member
                      • Apr 2012
                      • 68
                      • USA

                      #30
                      Re: Emerson lc407em1 Turns on screen only flashes, then off

                      Fixed this on my own.
                      Last edited by proaudiosoft; 02-01-2015, 01:42 PM. Reason: bad form

                      Comment

                      • tom66
                        EVs Rule
                        • Apr 2011
                        • 32560
                        • UK

                        #31
                        Re: Emerson lc407em1 Turns on screen only flashes, then off

                        It would be useful to say HOW you fixed it, for others in future.
                        Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
                        For service manual, schematic, boardview (board view), datasheet, cad - use our search.

                        Comment

                        • proaudiosoft
                          Senior Member
                          • Apr 2012
                          • 68
                          • USA

                          #32
                          Re: Emerson lc407em1 Turns on screen only flashes, then off

                          Replaced digital mainboard, no luck. Replaced inverter board, success. Fooled me because I would have thought TV would have stayed powered on with inverter removed from the circuit.

                          Comment

                          • nomoresonys
                            Badcaps Legend
                            • Jan 2013
                            • 12086
                            • U.S.

                            #33
                            Re: Emerson lc407em1 Turns on screen only flashes, then off

                            Originally posted by proaudiosoft
                            Hi, I am new to these forums, I have repaired several tv's , Just wanted to see if I could get some help on this one. The powerboard (and other boards) have no visible bad caps. Power seems ok at any marked voltage points on the power board. The inverter visibly looks ok too. When power is pressed the green light comes on, flashes 15 times, then back to red. I was thinking the problem is possibly the inverted since the screen just flashes very briefly then off like a second later. but If I unplug the inverter from the circuit, the TV still flashes green 15 times green then off. does this mean its not the inverter, or the tv is going into protection mode again without it?

                            And insight or help I would so much appreciate. I can post any pictures if need be. Thanks, Roger
                            you were on the solution in your first post,

                            Comment

                            Related Topics

                            Collapse

                            • smic717394
                              iphone XS turns off when press on screen.
                              by smic717394
                              Hi,

                              I have a iphone XS that came in for a screen replacement, the screen was badly cracked, and inside missing scues, on the back of the screen still the blue protector, the screen was a LCD. So we replaced the screen and all good, installed the screen and we noticed that pressing the screen with a bit of force but not excessive, the phone dies. After plugging the charger it turns back on, but again if you press it it dies. I open the phone again, and I can't see anything major, with the phone open, if I press on the logic board, battery, charging board, or even putting pressure on...
                              07-25-2024, 10:16 AM
                            • Rav_tangle
                              MacBook Pro 2011 turns on with keyboard light , screen dead
                              by Rav_tangle
                              Hi all , thanks for having me & I think this has been asked before but my case seems a bit odd.
                              I have a MacBook Pro , board 820-2915a and it turns on , chimes etc etc , keyboard lights up, fans spins , can turn caps lock on/off but screen is dead.
                              Iv tried the resets , shine torch through back logo , nothing , it seems the screen has no power. If I plug charger , it charges but if I disconnect battery it displays green light but won't turn on. Iv tried screen on with another board & it works & seems I'm not getting any voltage at pin 2 , next to ground pin .
                              is this...
                              05-31-2024, 04:09 PM
                            • krige
                              asus g750js ms1130c (203) turns on nothing on the screen
                              by krige
                              hi all i was wondering if you could help me troubleshoot this laptop. i bought the motherboard off eBay. it is used. i fitted the motherboard into the housing of the gaming casing and turned it on. nothing shows up on the screen. i checked the connectors and no missing connectors. i also removed the graphics card and nothing on the screen. i even reflashed the bios but still nothing on the screen. can it be a corrupt bios? i even used the HDMI port but it also shows nothing on screen. could this be broken screen or a dead ec chip?...
                              03-22-2024, 04:59 AM
                            • Ryan.man
                              Macbook 2017 with touchbar (A1706) won't turn on after removing the screen
                              by Ryan.man
                              Hello everybody! Posting this in hopes somebody has some expertise that leads to a clear path of troubleshooting that saves me a lot of time!

                              My macbook has the flex cable problem, the one that prevents the screen turning on. Ive been dealing with this for the last 3 years. Last year it went dead and I managed to fix it following youtube tutorials. But my fix wasnt the best, the problem returned a month later. This week, it went dead again. I again tried to fix it.

                              This time the original cable broke too close to the screen, it can't be fixed without tearing the screen...
                              02-04-2025, 12:23 PM
                            • Chrissygizmo
                              Samsung UE55JU6800K half screen dark
                              by Chrissygizmo
                              Hello everyone, I’ve just been given a Samsung UE55JU6800K smart tv as it had white spots on the screen due to the led lenses falling off. After refitting them & putting the tv back together I thought it was a nice easy fix for a free bedroom tv , then I tried it before screwing the back into place. I realised that the right side of the screen was darker than the other side, I removed the screen again as I thought the backlights had failed but they are fine.
                              I put the screen back in place & turned it back on . The screen seemed to be ok again but different screens on the same...
                              02-10-2025, 12:33 AM
                            • Loading...
                            • No more items.
                            Working...