Re: Can you test a silicone rectifier with a MM?
So which one shall I order?
So which one shall I order?
-
-
Re: Can you test a silicone rectifier with a MM?
The 30v that I see on the spec sheet of your link, or the one that ST shows in the link if it is available but not shown in the spec sheet, you should verify it first.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: Can you test a silicone rectifier with a MM?
Bought the one in my link as was local so no waiting or shipping.
But I'm a retard and even after you said check size it's too big! Only about 4mm so will have to move hole down 5mm. I'll need some advice on wiring, I'll put up some images when I'm back home.Comment
-
Re: Can you test a silicone rectifier with a MM?
Too big unfortunately. Going to have to return and exchange.
other options I have
http://uk.farnell.com/multicomp/vtx-...25v/dp/1675068
(80 VA, 2 x 25V, 1.6Amp)
http://uk.farnell.com/multicomp/mcta...0va/dp/9530509
(100 VA, 2 x 25V, 2Amp)Comment
-
Re: Can you test a silicone rectifier with a MM?
so why not the one i linked?
45 x 98mm
120VA 2 x 30V
i know the amps arent listed but it's not hard to see it's 2AmpLast edited by stj; 11-23-2015, 05:53 PM.Comment
-
Re: Can you test a silicone rectifier with a MM?
Not local, farnells is only 20mins away
98mm is a little bigger too. Original is 90mmComment
-
Re: Can you test a silicone rectifier with a MM?
25V 1.6A will be fine.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: Can you test a silicone rectifier with a MM?
Ok so have the new one and it fits fine, now wiring the thing
old one was
blue-grey & red-yellow
and was wires as so
Comment
-
Re: Can you test a silicone rectifier with a MM?
Disconnect the transformer terminals from the board, we need to find which two terminals on the board are directly tied together first.Last edited by budm; 11-24-2015, 01:39 PM.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: Can you test a silicone rectifier with a MM?
BTW, what is that small white connector with yellow and green wires for?Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: Can you test a silicone rectifier with a MM?
New one is
orange-yellow & black-red
Not sure what the dot . signifies next to orange and black assuming neutral?
So does this wiring seem correct
Comment
-
-
Re: Can you test a silicone rectifier with a MM?
I need the straight shot of the board to see which two terminals on the board are electrically tied together first.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: Can you test a silicone rectifier with a MM?
same orientation as the othersComment
-
Re: Can you test a silicone rectifier with a MM?
top two look tied
red grey in the old setupLast edited by mikay786; 11-24-2015, 01:59 PM.Comment
-
Re: Can you test a silicone rectifier with a MM?
get a datasheet for the new transformer.
you need to get the 2 outputs connected in-phase.Comment
-
Re: Can you test a silicone rectifier with a MM?
https://cdn.badcaps-static.com/pdfs/...54ebd5cbfe.pdf
the linked ones are positive right? as they go into the positive inputs on the big caps following the trace,Comment
-
Re: Can you test a silicone rectifier with a MM?
Just to double check ill be wiring like this then
Comment
-
Re: Can you test a silicone rectifier with a MM?
You will put the Yellow and black on those two terminals that are electrically tied together. You are forming center tap transformer.Attached FilesLast edited by budm; 11-24-2015, 04:04 PM.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
-
Re: Can you test a silicone rectifier with a MM?
orange red
yellow blackComment
-
I read EBOOK of Testing Electronic Component and found that
"In order to test the small blue resin coated ceramic disk capacitor which has 104 50v specification,it is possible to test this small ceramic capacitor by making use of analogue meter.
Set to times 10Kohm that has 12v output from the probe to check disorder of ceramic capacitor.
It is not uncommon that testing result of digital capacitance meter is okay,But It show shorted reading when you check it with analogue meter."
Is it really possible to test small ceramic disc capacitor with analogue... -
This is my first attempt at troubleshooting a board like this, I know I could just buy a new board but I'm curious to figure out how this works. I've been testing different components in the evenings this week and I think the problem is with the IC failing to start up for some reason. When the board is plugged in there is no standby voltage.
Then today it randomly sprung to life like a zombie but shortly died thereafter. I have no idea why it would have done that and its the first time I've seen it running. I discharged capacitors on the board last night, then it was sitting today.... -
Hello
I have power adaptor(220V/input, 12V 1.2A/output) which has symptom of fluctuating output DC voltage between 11.5V-12.2V.
So I opened its plastic case and when switched it on, I heard constant tik tik sound from inside its PCB.
I measured DC voltage between negative and positive pin of the largest capacitor(400v 10uf) and it was measured contant 300V.
I also measured ESR value of all capacitors and I noticed that one of capacitor(KMG 16v 470uf), which located in the secondary side, have high ESR value(10 ohm),So I replaced it with same specification NXH capacitor.... -
2+ year old TV with many (720? 65" version has 720) mini LED dimming zones. TV boots, has sound, panel picture can be seen with flashlight. No backlight. No TV model sticker on rear panel (Maybe Samsung service removed it, read below). Found the model # through the PSU and zoned LED driver board numbers.
PSU has a click near LED output circuit at 1 second interval, sounded like the 4x barrier rectifier area. Protective pastic liner under PSU shows heat signature on the Schottky Barrier Rectifier in this circuit. Found a shorted diode (2 diode per rectifier, failed rectifier labled... -
Back in 2020 i bought a (2nd hand) compact ATX psu to replace my current one. My PC case only fits very short ATX power supplies so i didn't really have the choice of buying a decent 80Plus unit. The current unit is a modded YoungYear unit that i made a thread about a while ago:
A "nice" YoungYear unit? - Badcaps
The "new" unit is a KDM-M6480 480W psu, the 480W number is a typical KDM bullshit claim of course, but the 24A rating on the 12V rail seemed reasonable and the "Active PFC" claim gave me a bit of hope that this was going to be decent-ish....
Comment