Lenovo NM-D562 v2.0 main EC programming help needed

[questore]

Hello Everyone,

I have this board that has an autostart as soon as i connect the charger (no POST) and restarts after 20 seconds. cannot be turned off.
I'm suspecting main EC firmware problem (IT8227E-192)
Since this board has only EC_KSI6 and EC_KSI7 pin on keyboard connector to the EC this cannot be programmed trought it.

I would like to know if anyone can give me instruction how to program the EC.
In the Vertyanov tutorial instructions I have seen that alternative is using 8pin direct cable soldered to board.
Anyone knows hows if that is working with ITE chips or just with ENE?
What software options i need to use?

[khaahk]

Are you sure it is 192 not 256?
You can use ite via i2c method, what's the JIG version?

[questore]

Are you sure it is 192 not 256?
You can use ite via i2c method, what's the JIG version?

I have not disassembled it yet so dont know it its a 192 or 256 I have only took a look at the 1.0 schematic and boardview
JIG is rev 4.2

[khaahk]

JIG3 and successor both support the i2c method. Connection via battery smb clk and data lines. 2 wires+gnd.

[questore]

JIG3 and successor both support the i2c method. Connection via battery smb clk and data lines. 2 wires+gnd.

OK but from where should I connect the wires and what software should i use

[khaahk]

Not sure what is JIG4.2, are you sure it is vertyanov?

[questore]

Not sure what is JIG4.2, are you sure it is vertyanov?

Now I dont know, I did not have any problem with it until this i2c.
I have ordered it from this:
ioprogrammer.com

[khaahk]

Then you have to contact the seller for software, as i understand Vertyanov has built into new version of his software a lock which might brick non-original programmer.