I'm trying to find out where i can purchase the two components highlighted in yellow. Or at least the value. thank you in advanced
-
Last edited by Bafury; 07-14-2018, 10:09 AM. -
Re: PS4 SMD HDMI Resistor and Diode (Where can I buy)
What model # PS4 is this picture from? I have several of the parts in inventory.-Thomas
I'm a hardware engineer focused on networking equipment for my day job. I void warranties and fix consumer electronics for fun. -
Re: PS4 SMD HDMI Resistor and Diode (Where can I buy)
can you upload any pictures please - they dont show on secure browsers if you link them.Comment
-
Re: PS4 SMD HDMI Resistor and Diode (Where can I buy)
Best bet would be ebay. Something like this.
https://www.ebay.com/itm/HDMI-Port-S...item2f1db3598dComment
-
Re: PS4 SMD HDMI Resistor and Diode (Where can I buy)
. is the diode a tvs diode ? dont see a resistor markingLast edited by petehall347; 10-10-2018, 05:18 PM.Comment
-
I lost one of the two hdmi outputs on a yamaha rx-a1050 receiver. Of course, it is the hdmi1 which has the arc capability which was useful. The second output hdmi works OK.
I got an hdmi breakout board which gave me access to the "little guys" in the hdmi. I did some gross DC voltage measurements to ground and found that the Data1 pair (4 and 6) had a lower voltage than the working hdmi.... 1.1v versus 2.9. All others pins seem to be OK. Further when plugged into a display, there is no video but a message on the screen which I assume is the display's status for the... -
I did an hdmi port repair for a PS5 and I lost the small diode z71 SOD923 on the back of the port. I did a trace repair for pin 19 of the port as well. Without the diode I get no display at all. I tried replacing the diode twice but after I get flux on it the marking comes off so I can't tell if I have it on the right orientation. When I measure I get a reading of 1(open) and 923 in diode mode. Is 923 a normal reading for these and also which side should the reading be with regards to the arrow on the board?... -
Hello Guys. Yesterday I was repairing a MacBook with no backlight. I noticed the resistor/diode RP802 is bad so I took it off. I also had a faulty motherboard that can't be repaired that had that resistor/diode on it (RP802). So it took the good RP802 off the faulty board. And when I had it on my tweezers it accidentally flew away. And now I don't know what to do. I 100% can't find it because of how small it is. Do you guys know any other diode/resistor that can work as the RP802
I'm a newbie to microsoldering and I'm still learning. All help is really appreciated
... -
PS4 1215A HDMI DIODE READINGS GOOD EVERYTHING GOOD BUT NO PIC? everything is good! what else can it be? if hdmi diode values are good that means encoder and filters are good right? idk what else it can be guys...01-05-2023, 12:32 AM -
Good day folks. Today I had to work on a power supply/battery charger which had some parts arranged in a manner which intrigued me. It is a proprietary board that's part of an alarm panel and it also acts as a charger for a backup SLA battery. It's a very basic supply, with no proper battery management: have a look at the terminals and you'll immediately see how it works. There's a 14v output and there's a "BAT" output, which basically just ties the battery in parallel to the supply, but not directly, instead through a diode and resistor, as outlined on the doodles I did on the back....
Comment