Basically as title says, my monitor died out and after reading some info here, I determinded that it was the power board caps, replaced them and everything worked for about a 3 weeks, then one day it died while I was using it.
The power LED goes blue when turned on (detects signal from computer) but no image on screen. I've tried using a flash light in a dim room to see if there was a image and there was none.
I've checked the fuse at F1 and when the monitor is on it shows 25v. I've replaced the 2 capacitors on the inverter board since they looked in bad shape but that didn't seem to help. Also when I check those caps, their recieve no voltage at all when the monitor is plugged in. I've also checked the wire connections to the ccfls (theres 6 total) and they aren't getting any voltages either.
Could use some help
The power LED goes blue when turned on (detects signal from computer) but no image on screen. I've tried using a flash light in a dim room to see if there was a image and there was none.
I've checked the fuse at F1 and when the monitor is on it shows 25v. I've replaced the 2 capacitors on the inverter board since they looked in bad shape but that didn't seem to help. Also when I check those caps, their recieve no voltage at all when the monitor is plugged in. I've also checked the wire connections to the ccfls (theres 6 total) and they aren't getting any voltages either.
Could use some help
Comment