Re: Gateway LP2407 / FPD2484 Replaced Power Caps and worked, 3 weeks later now it won
Ok, I set it for resistance and when I probed the negative on 1 side and positive on other, it was fluctuating 1-5
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Gateway LP2407 / FPD2484 Replaced Power Caps and worked, 3 weeks later now it won
@ jsog, the pictures linked are from another thread of the exact same monitor, not mines. I've replaced all the caps on the power supply including the 47uf with one from a repair kit.
I touched 1 end with the negative terminal and the other end with the positive, after the lcd has sat disconnected for a few hours, the result is no voltage showing up at all.
Unfortunately all I have is a rinky dink Cen-Tech 90899 that I borrowed from a friend, which looks really cheap....Last edited by Sny; 06-23-2011, 06:52 PM.
Leave a comment:
-
Re: Gateway LP2407 / FPD2484 Replaced Power Caps and worked, 3 weeks later now it won
I'm new to messing around with a volt meter, how would I test both sides? I tested by touching one side with negative and 1 side with positive.
The F1 fuse is located on the inverter board, located right next to the wires that's coming from the power supply.
I forgot to mention that I also replaced some caps on the image board since they looked shot aswell. Should I be seeing voltage in all caps? Some was 3.3, 5 and a few 1.8 but there was 2 on the image board that showed...
Leave a comment:
-
Gateway LP2407 / FPD2484 Replaced Power Caps and worked, 3 weeks later now it wont
Basically as title says, my monitor died out and after reading some info here, I determinded that it was the power board caps, replaced them and everything worked for about a 3 weeks, then one day it died while I was using it.
The power LED goes blue when turned on (detects signal from computer) but no image on screen. I've tried using a flash light in a dim room to see if there was a image and there was none.
I've checked the fuse at F1 and when the monitor is on it shows 25v. I've replaced the 2 capacitors on the inverter board since they looked in bad shape but...
No activity results to display
Show More
Leave a comment: