Re: CRT TVs
Showing my CRT Love ! Its hilarious that even today they are the superior display.
CRT TVs
Collapse
X
-
Re: CRT TVs
I blame ebay. "For parts or repair" "$600". Then the parts people wanting $50 for a knob.Leave a comment:
-
Re: CRT TVs
CRT TVs are given away free on a daily basis on my local kijiji. Everything from expensive Sony 36 inch WEGAs (200 pounds?) to other brand names like Panasonic, JVC, Sharp, etc.
Most people just want them out of their house to make way for the new thin TV and reclaim some space in their homes.
RPTV (rear projection) are also commonly found for free. Everything up to 60 inches and most in working condition.
People, however, have totally unreasonable expectations in selling their thin LCD/LED TVs. Broken LCDs are advertised for $150 to $200. Asking prices for working LCD/LED TVs are more expensive than what you can buy on sale.Leave a comment:
-
Re: CRT TVs
I only have one CRT monitor, but it's one of the few good CRT computer monitors I've seen. Most of the CRT monitors made after 1997 that I've seen had a blurry picture, along with some other issues. Only one whined, but it was obviously broken. My monitor buzzes, which is something I've never seen before.
I still remember the Compaq V55. That was the only CRT monitor that could actually be called Can't Read This. They all had a blurry picture from the factory, and changing the computer's video card affected how blurry the picture was. At best, it was barely usable.Leave a comment:
-
Re: CRT TVs
I bought this refurbished Toshiba 32JW9UA about 7 years ago and still works fine. Although it's difficult to show in a photograph, it shows a picture that amazes me every time I turn it on.
Although I always run it in SD mode, I can clearly notice when the source is HD.
The screen flickers too much in HD mode.Leave a comment:
-
Re: CRT TVs
It is a Toshiba TP48D51, not as high rez as what you're after, but works great for watching movies, TV, and game consoles. My family loves it.Leave a comment:
-
-
Re: CRT TVs
I personally dont like crt, especially repairing them when they fail alot that can harm you inside but they are reliable tvs. I personally prefer plasma I would take a non hd plasma over a full hd lcd haha. You are right though about the colours and response time however they are just too bulky and whine and nothing much any better about them.
Very nice. What kind of high grade units have you had the pleasure to view/work on?
You should share some pictures if you have them, or at least list some model numbers of the units that you have.
I agree that a CRT is an engineering marvel but I too think it has lived out most of its life. Digital displays are improved as time goes on. I love my gigantic rear-projection 3-CRT TV. This is something I would never have gone out and bought though, even when it was new. However it was thrown out with the trash and I salvaged it and repaired it just for the fun of it at very little cost to me ($24 in parts as I recall) and I love it now.Leave a comment:
-
Re: CRT TVs
no, but it makes very fast transitions for gaming.
like TEMPEST !!Leave a comment:
-
Re: CRT TVs
Vector displays are a type of CRT. It's not as well suited to home entertainment purposes as raster display are. Its not capable of drawing as complex shading needed in movie/video/TV production.Leave a comment:
-
Re: CRT TVs
vector displays are the real marvel!
specially colour ones.Leave a comment:
-
Re: CRT TVs
I agree that a CRT is an engineering marvel but I too think it has lived out most of its life. Digital displays are improved as time goes on. I love my gigantic rear-projection 3-CRT TV. This is something I would never have gone out and bought though, even when it was new. However it was thrown out with the trash and I salvaged it and repaired it just for the fun of it at very little cost to me ($24 in parts as I recall) and I love it now.
I wouldn't mind getting my hands on a freebie LCD or Plasma TV that is economically repairable. It'll happen someday I'm sure.Leave a comment:
-
-
Re: CRT TVs
I just love CRT TVs and Computer screens. I have a small collection of them in the attic :-)Leave a comment:
-
Re: CRT TVs
industrial crt monitor's are best.
RGB directly into the gun amps.
Leave a comment:
-
Re: CRT TVs
That is one piece of truth... PAL/PAL Plus is better than NTSC. But I still don't miss the old heavy CRT.Leave a comment:
-
Re: CRT TVs
I am lucky I still have CRT sets in UK excerlent picture still sorry for you guy's in USA NTSC sets (never the same colour twice) the pal system is far better than any plasma crap or LCD orLED TV. Any poor sole that has a plasma set has never seen a good picture.Leave a comment:
-
Re: CRT TVs
they shouldnt whine if the scancoils are properly made.
the only low frequency coil not potted is the scancoil assembly.Leave a comment:
-
Re: CRT TVs
I personally dont like crt, especially repairing them when they fail alot that can harm you inside but they are reliable tvs. I personally prefer plasma I would take a non hd plasma over a full hd lcd haha. You are right though about the colours and response time however they are just too bulky and whine and nothing much any better about them.Leave a comment:
Related Topics
Collapse
-
by cmonkeyTurned on my lovely plasma and after about 30 seconds the screen below showed up. None of the inputs are responsive, just the red light flashes when I push it. Remote doesn't work either. To turn it off I need to unplug it and when I plug it in again it turns back on to this screen.
I only found one reference to this issue with a different model but it didn't look super reliable. Only mentioned a 'main board fault'. The main board for this one is on ebay for $34 so might need to go with that.
Anyone seen this before?
Thinking about it some more, it happened...05-19-2023, 01:01 PM -
by handsworthJust wanted to share some information that I ran across when attempting to do the tape method on a tv with a shorted panel. I normally use magnifying glasses however while watching a you tube video, the person was using their phone. It seems that the Iphone has a magnifier app and wow, it works great. I have Iphone 11 and the app is built in. Pictures attached are screen shots. Made taping the pins a breeze. Also useful when reading the tiny print on the boards. Hope this helps somebody. ...
-
by rumi409 Hi,
I'm trying to resurrect a LG OLED C1 TV that has some panel banding. I used the TCON error bypass to get a picture. I was able to update the firmware as well. But when I performed a pixel cleaning to try to get the banding out, it made the image significantly worse. I tried to undo the effects of the pixel cleaning by performing a factory reset and IN_Stop, but that didn't work. Any way to reset pixel cleaning data?...1 Photo -
by Mustafa85Hi guys,
Any one has Emerson industrial PSU schematic, it has 3 electronics cards in one package please have a look at pics -
by ivtecHi folks i need some help from the electronics pros on a small audio amp for my old lcd tv that sound is too low on the speakers despite to be on the max volume, i know the issue is on the main board , the only solution is to buy a new board but i don't want to shell out 50 bucks for a board . I have seen in Utube some home made audio amps but i'm weary about those projects, i 've seen a audio buit with an STK audio amp ,. I don't have STK4142, i have STK4273, my question if this is not fake and works can i do it with STK4273 instead of STK4142? thanks https://www.youtube.com/watch?v=BcTZS5Y...02-04-2024, 10:42 AM
- Loading...
- No more items.
Leave a comment: