Hi mate, I messaged you on YouTube, not sure if you go on there much ?
Anyway sorry to bother you but I have a b&w zeppelin gen 1, I got it not working, changed 3 caps and it now works but I’m getting a low du du du du du like motor boating with any cable I plug into AUX it does it with my iPad, and phone and without anything on the cable is there something failed is it an easy fix?
Regards
Gary
ReeceyBurger123
Never Give Up !
Last Activity: 06-13-2025, 06:48 AM
Joined: 05-18-2014
Location: Telford
-
Re: Okay to use 6.3V caps on 3.3V line of PC PSU?
Ive used 6.3v on a circuit I made for a led supply. Its 5v been running fine for years not got round to sorting it yet Ill know if the psu voltage gets too high
-
Re: Synology DS1520+ no power
Hey im in telford too, bring it to me
Leave a comment:
-
Re: Synology DS1520+ no power
Inject voltage and see what gets hot. Also I did as google and there's people claiming open circuit resistors in this unit causing this not short. See how much power is being drawn from the mains when the device is connected. Does anything get hot ?Leave a comment:
-
Re: RTX 3070Ti works normal, but when let 10min to work on full it crash
Yep could be ram or cpu needs reball, I’ve done 2 with driver/load crashes etc.Leave a comment:
-
Re: QUAD 66 Pre Amplifier Anyone Worked On Before ?
Cpu Ic was faulty, no fix in the end. Could not get it stable in the end. Thanks CL hope your good
Leave a comment:
-
Re: LG 55LW5300 Backlights on, "Black Screen"
Could be nand and spi, see if panel gets sca. Could also be a panel level short or tcon.Leave a comment:
-
Re: LG 43LJ594V PS pulsing. TV won't go to stby
See if there's shorts to gnd, I've had this board with mlccs short....Leave a comment:
-
Re: LG55UB850V no picture or audio - flashing LED's help please?
From my experience with similar boards, seems more like a ceramic capacitor plague developing. In a few common areas they short.Leave a comment:
-
Re: Toshiba 32D1333B <Firmware needed>
Need to replace whole spi and dump onto new Ic, otherwise it will fail again. I don’t bother with mb95’s and more. Swap it for mb82Leave a comment:
-
Re: Microsoft Surface Pro 5 1796 - No Power
Inject voltage see what gets warm. I’ve had a bad MLCC in the mix of the cpu caps on the pro 5 ��Leave a comment:
-
QUAD 66 Pre Amplifier Anyone Worked On Before ?
Hey everyone, no images just yet of the device. Wanted to ask if anyone has experience with this preamp ? It's intermittent something by the the main IC or the IC itself is faulty. IC 302 on the schematic, if you freeze near this area the amp works. So far I've done the following:
Soldered cpu to board-removed 40 pin socket
Replaced 4mhz clock
Replaced all caps
Cpu has clean 5v
Caps near cpu are ok
Resistors and resistor pack test ok
All other voltages are there and working
Two small ZTX750 transistors near by I have on order,... -
Re: LG 43UM6910PUA backlight on, but no picture
Connect to the hdmi and see if you can move the tv to that input and play sound, this is my method for ruling out main boards these days.Leave a comment:
-
Re: 43pus6401/12 - no picture, blinking ambi lights
Firmware or cpu fault, these Phillips boards are trash.
[url]https://youtu.be/BD4J1JQcB7A[/url]Re: 43pus6401/12 - no picture, blink...J1JQcB7A[/url]Leave a comment:
-
Watches can have bad caps too! 735XT Repair
I had some time today spare, normally we would just board swap to reduce labour time. This Garmim 735 was stuck in a boot loop. Battery shutting down the voltage (bms shutdown) decided something could be short so went hunting.
Found some shorts near the cap I replaced, so put 1v and some IPA this one soon showed up. Replaced the cap and fixed! Just thought I'd share
...
-
Re: Lg55lv4400ua
BGA issue had it on these boards.Leave a comment:
-
Re: Zotac 1070 mini
Doesn’t matter whack the highest value on you can.Leave a comment:
-
Re: Polaroid P43D300FP
The software on the 11P is useless. Can you try opera or another app with VPN ?Leave a comment:
-
Re: polaroid p40led12
Apply 3.2v to blon mate, I’ve had luck with this on ips20 series. The ones for the 55” are set up different though.Leave a comment:
-
Re: Troubleshooting B&W Original Powersupply
Im half way through making a repair video of the zeppelin generation 1.Leave a comment:
No activity results to display
Leave a comment: