-
-
-
Re: LG 65UH5500-UA common problem?
i don't think this pin the problem, see the tab of the effected side.. you may have U ribbon cable on it.. if yes then its just fitting it again,Comment
-
Re: LG 65UH5500-UA common problem?
by tab do you mean the tab connecting it to the glass panel?Attached Filesif you find these attachements useful please consider making a small donation to the site
Comment
-
-
Re: LG 65UH5500-UA common problem?
NOT this, on the board... take out the speaker and the metal cover of the effected side.. see are there U ribbon cable as its 65 it may have 2 or 3.. many UHD used U ribbon.. hope yours tooComment
-
Re: LG 65UH5500-UA common problem?
There are no U ribbons that I can see. Only those 2 ribbons I showed and another ribbon that is not attached to the glass panel.
Even after removing everything when changing the LED strips, there were no other ribbons besides the ones seen here. Moved the speakers in this pic.Attached Filesif you find these attachements useful please consider making a small donation to the site
Comment
-
-
Re: LG 65UH5500-UA common problem?
of course you have U ribbon..i can see one on both side its the brown color you may have another one hidden on the photo... this U ribbon.. seat them correctly on the effected side
edit i marked them on yours photoAttached Filesif you find these attachements useful please consider making a small donation to the site
Last edited by Diah; 05-07-2020, 03:32 PM.Comment
-
-
Re: LG 65UH5500-UA common problem?
U ribbons see photoAttached Filesif you find these attachements useful please consider making a small donation to the site
Willing to help but I'm no expert.Comment
-
-
Re: LG 65UH5500-UA common problem?
Just tried switching the ribbon from the side that was working to the defective side and same result
I will try messing with the U-ribbon on the side that is defective.
Hope it works.
I should probably return the ribbons I ordered from ebay then right?Comment
-
Re: LG 65UH5500-UA common problem?
Here is the U ribbon of the defective side, how can I seat it correctly? It looks to be in properly, I never took them out when replacing the LEDs.Attached Filesif you find these attachements useful please consider making a small donation to the site
Comment
-
-
Re: LG 65UH5500-UA common problem?
you need to provide a better picture of the bottom edge board on the side showing the gray vertical bar so the forum can see how that side is interconnected. As pointed out, the "U" ribbon cables interconnect the bottom edge boards to complete the drive paths. However, on sets of this size, there may also be side tabs and / or side edge boards (similar to the bottom one) that also might have some interconnect cabling.
further as a test, you can disconnect the "u" cable on the "bad" side, you should then see about 1/4 quarter of the picture go white (or black) depending on design... including the grey area should be "gone".Last edited by budwich; 05-07-2020, 04:42 PM.Comment
-
Re: LG 65UH5500-UA common problem?
Oh man, think I just found the culprit
Removed the tape to see the driver board on the defective side and about 3/4 of that tab is lift off the board.
Is there anyway to fix this or am I a goner?Attached Filesif you find these attachements useful please consider making a small donation to the site
Comment
-
-
Re: LG 65UH5500-UA common problem?
yep that's the problem... others may have some ideas.Comment
-
Re: LG 65UH5500-UA common problem?
what ever you do, don't take it any further off as right now it is basically holding "alignment"... you might get lucky by very carefully cleaning what you can and possibly holding it back down with something.Comment
-
Re: LG 65UH5500-UA common problem?
Very tedious work, there's plenty more on youtube: https://www.youtube.com/watch?v=o_iBM5JgE28Comment
-
Hi there,
Recently I bought broken Bowers & Wilkins PX7 S2, the problem with them is that battery discharges on its own even with headphones turned off. It is a quite common issue with this model and even with model higher PX8.
With help of thermal camera I found out that there is one IC that is hot even with headphones turned off. To check if I'm correct I bought another PX7 S2 working one and replaced small charging board with this IC and problem solved, battery no more drains on its own. After changing board back to original problem returned so I'm 100% sure problem...05-30-2025, 01:11 PM -
As stated by the person I collected the TV from, it just stopped working overnight. However, I still gave it a go to try and repair it.
There is a thread on the same TV but with slightly different issues where they had to tape connection points on the ribbon cable, so I want to see if this is repairable by any chance.
After bringing it home and plugging it in, the TV turned on with its backlight working but had no picture. After removing the back cover, the first thing I tried is to unplug one of the ribbon cables and the situation is as follows.
Left... -
Hello,
I have a XPS 9520 with broken daughter board and missing ribbon cable. I can fix the board by replacing the connector, but I can't find the correct ribbon.
There is 2 models, idk which one is needed on my laptop.
0xkvng
00vpr2
Daughter board is LS H822P. When I check for a palmrest, the board attached to have a 0xkvng ribbon. But when I check for LS h822p, it's 00vpr2 ribbon...
Someone can help me with that please ? Idk the difference between these 2 ribbon but they definitely doesn't look the same..
thanks... -
I recently got my hands on a 60" Panasonic P60ZT60 plasma tv (european model) that has some strange issues along with an 8 blink code.
It know this tv is getting old but it was once considered one of the best plasmas ever made, and i think it is still holds on to that even by todays standards.
So, long story short. When i first got the tv it had a very bright washed out picture with very raised blacks in all picture modes and i couldn't find the cause in the picture setting menus.
After doing a factory reset this problem was gone and the picture was back to...01-06-2025, 06:02 AM -
Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.
The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.
Original T-con:
Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.
First replacement T-con:
I thought it might be t-con and ordered new t-con from china(supposedly tested)...
Comment