Re: Philips 32PHH4509/88 not responding to remote/not turning OFF
backlight ON has 3.3V i will open the panel to see what is there . thanks a lot
backlight ON has 3.3V i will open the panel to see what is there . thanks a lot
-
-
Re: Philips 32PHH4509/88 not responding to remote/not turning OFF
If you are looking the service manual, it is downloadable from this page:
https://www.electronica-pt.com/esque...ileinfo/33684/Comment
-
This is my first post on this forum, and my first attempted repair of a modern flat-screen LCD-TV (though I have repaired a few LCD-monitors, all with Elco-problems (high ESR). I have repaired my fair share of TV-sets and VCRs in the past ('90s) and was fairly familiar with the different Philips chassis (KT-3M, K12, K2, K3, K7 are some that come to mind). So I have a fair bit of experience on old sets. Obviously, modern TV sets are quite a different cup of tea.... no HOT or flyback-transformer inside, for starters....
The set came into my possession by accident,... -
I have a hitachi 75hl16t64u tv in for repair and it is driving me crazy.
It came in for a power issue which I have finally resolved by replacing the power supply.
The current issue is that the TV does not respond to the remote control. I have replaced the IR sensor board with a used one but the fault persists.
Anyone have a clue how to fix TV?
FYI: I have checked the remote work s by pointing it at my camera on my phone.... -
Hello guys,
First post here so sorry if ill do any mistakes..
Got TV for repair, Philips 32PFL3008H/12, Main board VESTEL 17MB95S-1 170912. TV turns on, has image and everything, but there is no response to remote controll. Checked IR receiver - it gave no signal at all. Replaced IR receiver with no luck, still no response to remote, but i got proper waveform when any button is pressed. so far i tried ruling out software - flashed EEPROM / BIOS / NAND, no luck. At this point, when turned on, TV displays message "SHOP MODE", message closes, tv works as intended.... -
Hello,
my remote control for my beloved TV (Philips 47PFL5028K/12) is no more working.
Codes of the remote should be :
PHILIPS 996590004895, YKF314-005
It's blinking endlessy when I insert AAA batteries.
Checked cap seems ok, the transistor (i think is that) seems good
IC not checked.
I thought also to a stuck key.
I switched cap and seemed to be ok but it restarted blinking endlessy again..
May the IC fail if battery polarity is inverted? because my son told me he did that ...
The schematics... -
Hi all
I've just repaired the backlights on this tv. I didn't get a remote with it so I'm using a universal one. The tv works properly via the buttons on the back but the only remote command it registers is the power off. It will power on if I try immediately after switching off, if I leave it until the standby light stops blinking then it won't turn on again from the remote.
I don't think the remote is at fault as I've got other remotes that do exactly the same thing.
Any help would be really appreciated....
Thank you...
Comment