I have a Hitachi LE42H508 with vertical lines, I wanted to know based on your guys experience whether the panel is the issue or the possibility of the Tcon or main board? originally there was one or two vertical lines that would come and go, then the past several weeks my daughter stated to me that there were multiple lines that would come and go. I am not sure if that is symptoms of a bad panel or the TCON/MB having issues. I did disconnect the TCON one side at a time and results can be seen in the photos.
Hitachi LE42H508 Vertical Lines
Collapse
X
-
Tags: None
-
Re: Hitachi LE42H508 Vertical Lines
Panel failure not fixable, expect more rows to start dropping.Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !
https://www.facebook.com/Telford-Tel...7894576335359/ -
Re: Hitachi LE42H508 Vertical Lines
+1 panel.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
Related Topics
Collapse
-
by Stanley1843Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesnโt display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
-
Channel: Troubleshooting Computer Displays
-
-
by Daren87Hello everyone,
I've recently been given a Sony 8k Z8H. It's got a white screen with two vertical black bars. At times it's given me the 5 blink Tcon code. Testing voltage on the Tcon I can see some low or missing voltage. I've done a basic visual check of cables and the COF. Not seeing anything obvious. The original Tcon seemed to have good caps until turning it over. On the bottom I found maybe 10 caps with both sides of the caps shorting to ground. I thought ok these caps and likely other components on the Tcon are shorted so let's try a replacement Tcon. I just received the... -
by gpo23Hello,
i order a t-con because i had bad colors on my SONY KDL-40V3000 :
With the new t-con the color are good but there are vertical lines on all the screen :
I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)
Is there a way to fix the vertical lines on the new t-con ?
Thank you for your help
gpo23... -
by x_orange90_xJust bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
-
by jason123*** Board Photos here : https://www.badcaps.net/forum/showth...light=LE55U516 ****
TV Works fine, but there are thin vertical lines (not necessarily all the way from top to bottom - sometimes top to 1/3 or 2/3 of the screen) and these are not always there. They seem to come and go depending on the type of picture, colors,...
There is no firmware update for this model per the manufacturere.
I did a full factory reset.
When I got it, it had bad backlight (a couple of bad LEDs) - fixed these only to find the vertical lines. I Reseated ribbon... - Loading...
- No more items.
Comment