Panasonic TCP-50G10 3 Blink error

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Morts
    New Member
    • Jan 2014
    • 6
    • USA

    #1

    Panasonic TCP-50G10 3 Blink error

    I am trying to figure out my issues on my 2009 model G10. The TV has been broken for some time now. I really liked this TV and would love to get it working again. I have replaced the A board which the manual says the the only cause of a 3 blink error is the A board. I am possibly thinking it could be the P board. When I test pin 5 and 6 on P25 I do not get close to 5V. If I am reading correctly from my research the 3 blink error is no 3.3V correct? So is there any other things I can check to make sure my P board is bad and is the culprit? Thanks for any help.
  • tw2005
    Badcaps Legend
    • Oct 2011
    • 6457
    • Australia

    #2
    Re: Panasonic TCP-50G10 3 Blink error

    disconnect, SC2,SS11, P35, 3 white ribbons at the A-board.

    Turn it on and see if it still 3 blinks. Turn it off once you have the result. Don't reconnect anything for a good 5 mins or so especially p35, sc2, ss11 . Measure for residual voltages if in doubt. When running SC2, ss11 ~200V, p35 ~60v. Arcing P35 can destroy the panel on reconnection.

    If there is no 3 blink then I'd be suspect of the SC board which may have a shorted 15V line and shorted transistors etc.

    Comment

    • Morts
      New Member
      • Jan 2014
      • 6
      • USA

      #3
      Re: Panasonic TCP-50G10 3 Blink error

      I disonnected SC2 SS11 and P35, also the A board ribbons, when i powered it on i got no blink error codes. Thanks tw is there any other tests to verify bad SC board? Thanks for the tips but why no 5v at pin 6 on P board?

      Comment

      • Alastair E
        Chief Womble
        • Mar 2013
        • 1963
        • U.K.

        #4
        Re: Panasonic TCP-50G10 3 Blink error

        Locate and test Q661 on SC board. If short--there'll be a whole load more short in there too....
        TELEFIX

        How PLASMA SCREENS WORK, X-SUS and Y-SUS what they do--
        http://www.irf.com/technical-info/appnotes/an-1088.pdf
        PLEASE DO NOT EMAIL ME PRIVATELY FOR REPAIR ADVICE. QUESTIONS BELONG ON THE FORUM!

        Comment

        • Morts
          New Member
          • Jan 2014
          • 6
          • USA

          #5
          Re: Panasonic TCP-50G10 3 Blink error

          How do I test it?? Thanks

          Comment

          Working...