PHILIPS (42PFL7623D/10) 2 BLINKING RED LED's
Collapse
X
-
Comment
-
Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
-
Re: PHILIPS (42PFL7623D/10) 2 BLINKING RED LED's
Ive tried to search all the usually places for a schematic for the power supply all the numbers you have gave so far i dont get any luck on finding one, can you take a really good picture of the power supply so when we zoom in on it we can read the board markings etc, failing that its up to you if you want to board swop ie a power supply or a mainboard just make sure they have a good return policy if there bad on arrival.Comment
-
Re: PHILIPS (42PFL7623D/10) 2 BLINKING RED LED's
Ive tried to search all the usually places for a schematic for the power supply all the numbers you have gave so far i dont get any luck on finding one, can you take a really good picture of the power supply so when we zoom in on it we can read the board markings etc, failing that its up to you if you want to board swop ie a power supply or a mainboard just make sure they have a good return policy if there bad on arrival.
If I find a fix ill update the thread then.
Thanks to all who have helped to find a solution anyway .
All the best .Comment
-
This topic was opened a long time ago, I am writing this in case it might be useful for a friend. I have been dealing with the same problem for days, these models give the LED bounce error 2 times when there is no speaker connected. Please connect a speaker. Or, to perform the operation with the lid open, connect a 4.7ohm resistor to the speaker outputs, the system will perceive these resistors as speakers, so the device will not give this error.Comment
-
Related Topics
Collapse
-
by PipolupsHi there !
I'm having an issue for several weeks with my quite old K70 LUX RGB keyboard. I haven't used it for few months, and once I setup up again my desktop computer, I got several dead LEDs on that keyboard. I tried the Corsair troubleshooting thing (disabling options in iCUE, ...) but nothing changed so I conclude that for some reason some LEDs went in retirement...😅
Decision taken to change these LEDs as I have access to desoldering iron and binocular magnifier, I wrote a ticket to tech support, hopping to obtain the LEDs reference and... They refused to tell me 🙄...10-08-2024, 11:58 AM -
by horus100Hi, I've a problem with my laptop toshiba Z30: do not swith on and thare are 2 blink leds, white and yellow, blinking 2 times each one. I have disconnected the battery, CMOS battery, and reset bios but no effect, the laptop remain still switched off. Do you have any suggestion? Thak you!
-
by gkolioHi have problem with 4 reds blink take lot help that forum and tell me change led strips and all going very good tv alive now but in down left have pink tint little and see only in white pages what wrong doing?
-
by JuanLI can't get the laptop to start. When pressing on, the laptop stays with the LEDs blinking 1 white and 3 yellow.
According to google this is due to the RTC battery. It was on 2.9 VCD and I have changed it for a new one, but it remains the same.
I have removed the M.2 NVME disk, I have also changed from slot 1 to 2, the only 8 GB slot RAM module, but I can't get out of this point.
The motherboard is an LA-G717P
What else could it be?
Thanks for the help and Happy New Year.01-10-2022, 12:54 AM -
by HP32SiiThis is my first post on this forum, and my first attempted repair of a modern flat-screen LCD-TV (though I have repaired a few LCD-monitors, all with Elco-problems (high ESR). I have repaired my fair share of TV-sets and VCRs in the past ('90s) and was fairly familiar with the different Philips chassis (KT-3M, K12, K2, K3, K7 are some that come to mind). So I have a fair bit of experience on old sets. Obviously, modern TV sets are quite a different cup of tea.... no HOT or flyback-transformer inside, for starters....
The set came into my possession by accident,... - Loading...
- No more items.
Comment