Need jvc eeprom

[Chicd]

Have jvc jlc42bc3000 stuck on logo. All voltages are good...can't find a source for eeprom...any help?
New to tv repair

[vinceroger69]

Re: Need eeprom

maybe worth a read
https://www.badcaps.net/forum/showthread.php?p=596835

[Chicd]

Re: Need eeprom

Been all over that posting....have all the correct voltages...no visibly bad caps and yet still stuck on logo. Cleared once and I was running DVD....powered down then back on to logo again. All indications are eeprom. Can't find right one on board or any info online....?

[vinceroger69]

Re: Need eeprom

if you freeze the eeprom does it start if so maybe you can freeze it read the data quick and write it to a new chip theres a few guides on you tube showing this

[Chicd]

Re: Need eeprom

Need to find it on the board....froze all I thought were there and no change...
Can't find a schematic/board layout for that model...

[vinceroger69]

Re: Need eeprom

possible u18 eeprom whats the part number of it?

[Chicd]

Re: Need eeprom

Cant locate U18...

[Chicd]

Re: Need eeprom

too obvious....was looking for smaller one...
P13HDMI
2410 AFFE
Y1105GE

[vinceroger69]

Re: Need eeprom

sorry ignore u18 thats not the eeprom on this board i was looking for info for another set at the same time as looking for info on yours, did see see this post regarding the nand flash chip issue
https://www.badcaps.net/forum/showthread.php?t=49489

[Chicd]

Re: Need eeprom

Read all thru that post...tried freezing etc. Have all the correct voltages etc.
I'm stuck