Re: Sony Bravia KDL 46hx820 6 blinks
been doing that and have about halfway traced back so far from connector and found no voltage yet
been doing that and have about halfway traced back so far from connector and found no voltage yet
-
-
Re: Sony Bravia KDL 46hx820 6 blinks
Anyone have a cheap power supply and mainboard for this sony 46hx820?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
What are the part numbers(on stickers)?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
I havea a 46HX820 with that getting a 4 blink , i check the ribbon that @freakaftr8 is saying .
any ideea ?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
help ?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
?Comment
-
Laptop motherboard DA0NJJMBAG0
PROBLEM-WHEN I PLUG THE CHARGER WITHOUT BATTERY THE CHARGING LIGHT BLINKS AND WHEN I PRESS POWER BUTTON THE CHARGING LIGHT STOPS BLINKING AND STAYS ON BUT THE POWER LIGHT DOESNT TURN ON AND LAPTOP ALSO DOESNT TURN ON NO FAN SPINS NO KEYBOARD LIGHT.
CHECKED- ON S5 STATE TGE LAPTOP HAS 5V ON USB 3.3V BUT I DIDNT GET 1.8VOLTS ON BIOS PIN NO 8 WHILE PLUGGED IN AND EVEN ON S5 STATE.
GUIDE ME WITH THE PROBLEM..
SUMMARY-
1.NO 1.8VOLTS ON BIOS PIN NO 8.
2.S5 STATE ((PRESSING POWER BUTTON)))VOLTAGES ARE PRESENT... -
I have a Sony Bravia KDL-40V2500 that will not power on. The indicator flashes red 3 times.
I do not hear any sound and I cannot see any backlight.
I have tried disconnecting every cable on each board one at a time to see if anything changes.
The only change is when I disconnect AC-DET cable on the Power Supply board or on the other end if I unplug the CN7009 connection on the B-Board and try to power on the TV the indicator will stay on solid green until I power off.
My friend ordered another used power supply board but it is also doing the red indicator flash 3 times... -
Hello,
I have problem with SONY 55X90J. After several check status is as below;
1. Running power board as stand alone:
TCON_12V =~ 12.6V
EVDD V On Max 24V= 19V.
2.Running power board with TCON as stand alone:
Effect as below, attched.
3. When bottom LVDS cable is disconnected no blinks, but of course no TCON 12V and EVDD.
"I'm almost sure it's a defective panel, but maybe someone has encountered a similar issue on their screen.
Best regards.... -
Hi everyone. First post on Badcaps!
I am trying to fix a Sony 940E from 2017 that either starts normally (and works perfectly until turned off) or goes straight to the 6 blinks error code without showing anything on the screen. It is frustrating to know that it can still work perfectly but is barely usable because of the difficulty starting it up. I am willing to try to short the BL_ERR but I would like to avoid that if possible. Does anyone have a view on this? Thanks a lot.... -
Hi,
I’ve got a Sony KD-65XE8596 here that has no standby light coming on. I’ve tested the power board with the test meter, the TV needs 3.4 for the standby but only getting 2.4. Anything that I can change/check on the board to get it working? Pictures of the board are included.
cheers...
Comment