Re: Sony Bravia KDL 46hx820 6 blinks
been doing that and have about halfway traced back so far from connector and found no voltage yet
been doing that and have about halfway traced back so far from connector and found no voltage yet
-
-
Re: Sony Bravia KDL 46hx820 6 blinks
Anyone have a cheap power supply and mainboard for this sony 46hx820?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
What are the part numbers(on stickers)?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
I havea a 46HX820 with that getting a 4 blink , i check the ribbon that @freakaftr8 is saying .
any ideea ?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
help ?Comment
-
Re: Sony Bravia KDL 46hx820 6 blinks
?Comment
-
Laptop motherboard DA0NJJMBAG0
PROBLEM-WHEN I PLUG THE CHARGER WITHOUT BATTERY THE CHARGING LIGHT BLINKS AND WHEN I PRESS POWER BUTTON THE CHARGING LIGHT STOPS BLINKING AND STAYS ON BUT THE POWER LIGHT DOESNT TURN ON AND LAPTOP ALSO DOESNT TURN ON NO FAN SPINS NO KEYBOARD LIGHT.
CHECKED- ON S5 STATE TGE LAPTOP HAS 5V ON USB 3.3V BUT I DIDNT GET 1.8VOLTS ON BIOS PIN NO 8 WHILE PLUGGED IN AND EVEN ON S5 STATE.
GUIDE ME WITH THE PROBLEM..
SUMMARY-
1.NO 1.8VOLTS ON BIOS PIN NO 8.
2.S5 STATE ((PRESSING POWER BUTTON)))VOLTAGES ARE PRESENT... -
Hola a todos, necesito el esquema electronico de la placa 1-983-356-11 de un televisor sony bravia KD-65AF9.
Hello everyone, I need the electronic diagram for the 1-983-356-11 board of a Sony Bravia KD-65AF9 television. -
Hi there,
I see a couple of posts related to the troubleshooting of similar TV. The one I have is acting slightly differently and I'd love your help.
So it has the 5 blinks. Previous owner got a TCON, no luck. Got a new Main board (though he didn't do the USB firmware update), again, no improvements.
I see 2 posts that are relevant:
https://www.badcaps.net/forum/troubl...j-oled-5-blink
https://www.badcaps.net/forum/troubl...g-hardware-dev... -
I have a Sony Bravia KDL-40V2500 that will not power on. The indicator flashes red 3 times.
I do not hear any sound and I cannot see any backlight.
I have tried disconnecting every cable on each board one at a time to see if anything changes.
The only change is when I disconnect AC-DET cable on the Power Supply board or on the other end if I unplug the CN7009 connection on the B-Board and try to power on the TV the indicator will stay on solid green until I power off.
My friend ordered another used power supply board but it is also doing the red indicator flash 3 times... -
sony bravia kdl-43w756c, no power, no sound
the charger brick has 19,2-19,3 vcc
changed the inverter board same result.
where should i start?
cheers
Comment