waybel
Senior Member
Last Activity: Today, 08:46 PM
Joined: 11-12-2014
Location: ontario
-
Yes... -
You are correct.With the risk of doing more damage than good after installing new LED lights i bought a $40 board and installed it and the tv works fine.Thanks to all...Leave a comment:
-
Where would be a good spot to disconnect pin 4 on the pictures i sent and then where do i get 3.5 volt feed?...Leave a comment:
-
Are we still going to try this?...Leave a comment:
-
Ok well then i guess LG changed the number from the old board or someone changed this board.This board is a EBT63838801 and the LG site says the correct board is a EBT63838802.Is it possible that more than 1 board will work?...Leave a comment:
-
Could someone tell me what main board will fit this tv.The one that is in it reads EAX65610207 EBT63774501 .The LG site says it should be EBT63838802 .Another site said EAX65610206 Some of these boards are dirt cheap but i don't want to buy one then it doesn't work.Why do i have to keep putting the image verification every time i ask a question on here?Leave a comment:
-
I used a hot air station but no luck...Leave a comment:
-
Leave a comment:
-
So you want me to unsolder pin 4 ?Leave a comment:
-
pin 4 is 2.1 volts...Leave a comment:
-
tried that also.If the processor wasn't working shouldn't it be cold?When the tv is turned on it is warm to the touch.Or could it be that some of it is not contacting but still works?...Leave a comment:
-
I warmed it up 3 times with my hot air but no changeLeave a comment:
-
Got it from a guy that bought it new .No the standby light powers on .Hit remote it blinks 3 times and goes out as it should.Changed the leds because some of the reflectors had fallen off so replaced strips while i had it apart .Looks like i need to find another main board...Leave a comment:
-
no nothing workingLeave a comment:
-
The audio optic is not lit red and the screen is fine,I had it all apart to change LED stripsLeave a comment:
-
Just looking quickly on various places on main board found 1.2 V 3.3V 3.5v 5v 12v and 24vLeave a comment:
-
yes...Leave a comment:
-
Red is audio amplifier.The yellow i believe is a 16-Bit Single-Chip MicrocontrollerLeave a comment:
-
the yellow chip says 100GEA 527FZOA
the red chip says NTP7513 T5000266-1AF 15285...Leave a comment:
-
Leave a comment:
No activity results to display
Leave a comment: