Hisense H55U7B vertical stripes

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Davi.p
    Hobbist
    • Sep 2009
    • 4264
    • Italy - Milan

    #21
    Ok to be more precise, needs to replace completely the old solder, If my suspect Is right...

    pS:
    to have a confirmation, the half test image gets Better with the passing seconds?
    My suspect Is now different, i think you have problems with the cof Tab where the half connected side displays only bars and no image, leave alone for now the task of resoldering, try this other task, keep a freezing air can or compressed air upside down or butane gas, freeze a lot the cof Tab more towards side and with all connected test normally the TV..
    Last edited by Davi.p; Yesterday, 10:03 AM.

    Comment

    • Diah
      Badcaps Legend
      • Feb 2013
      • 6343
      • Germany

      #22
      scarp it

      Comment

      • lotas
        Badcaps Legend
        • Jan 2016
        • 4458
        • Russia

        #23
        And what will happen when using butane gas when freezing the chip and turning on the TV, a small spark and there is no owner of the TV and apartment!

        Comment

        • nomoresonys
          Badcaps Legend
          • Jan 2013
          • 12079
          • U.S.

          #24
          Originally posted by lotas
          And what will happen when using butane gas when freezing the chip and turning on the TV, a small spark and there is no owner of the TV and apartment!
          +100, Thats just about what would happen too.

          Comment

          • Davi.p
            Hobbist
            • Sep 2009
            • 4264
            • Italy - Milan

            #25
            I don't know what you are complaint of Lotas, butane is very volatile, he will turn on the set surely after no more gas is around.. it takes few seconds.. we begin again with these sterile polemics, with the "known party pooper" around like vultures..

            PS: The vulture here criminalized a website change and telling he disapper from here and 5 min. he are here again crushing the olives to me and the staff.. in italy it is called "uomo di m*rda senza orgoglio"... how can this happen?!
            Last edited by Davi.p; Yesterday, 04:18 PM.

            Comment

            • nomoresonys
              Badcaps Legend
              • Jan 2013
              • 12079
              • U.S.

              #26
              So this monkey has his nose out of joint again...just because I agree with someone that his "testing" suggestions are hazardous. He IS INDEED just a joke.

              Comment

              • nomoresonys
                Badcaps Legend
                • Jan 2013
                • 12079
                • U.S.

                #27
                complain complain complain yada yada ...So how do I get davi back on the IGNORE list??

                from admin - go to your profile and then edit your settings. under accounts you can add to ignore list
                Last edited by nomoresonys; Today, 05:10 AM.

                Comment

                • Document Archive
                  Administrator
                  • Feb 2024
                  • 115466
                  • -

                  #28
                  Just to address the experts on this post complaining about the new layout. previous vbulletin had major security issues so there was no choice to upgrade. I have made alternate (including dark mode) available in the footer and will release more soon.

                  As for being ad revenue orientated. this site makes a significant loss each month which is only partly subsidized by ads.
                  User submitted datasheet, schematic, boardview, service manual, firmware, bios, & software.

                  Comment

                  Related Topics

                  Collapse

                  • Daren87
                    Sony 8K XBR-75Z8H White Screen Vertical Bars Tcon Code. Help Needed🙏
                    by Daren87
                    Hello everyone,

                    I've recently been given a Sony 8k Z8H. It's got a white screen with two vertical black bars. At times it's given me the 5 blink Tcon code. Testing voltage on the Tcon I can see some low or missing voltage. I've done a basic visual check of cables and the COF. Not seeing anything obvious. The original Tcon seemed to have good caps until turning it over. On the bottom I found maybe 10 caps with both sides of the caps shorting to ground. I thought ok these caps and likely other components on the Tcon are shorted so let's try a replacement Tcon. I just received the...
                    08-13-2023, 03:25 PM
                  • ahoonid
                    MacBook A1990 vertical stripes on external screen
                    by ahoonid
                    Hey everyone,

                    I bought a MacBook A1990 with no screen. I bought it knowing the motherboard was defective but wasn't sure what the problem was until I received it. It actually turns on but as you see from the attachment, it has vertical stripes, on an external screen!!

                    The board is neat. Not opened before for sure. Just a little dust, nothing more.

                    Recovery using wifi can be opened, as can also be seen in the photo but it doesn't go all the way through after connecting it to a wifi. It downloads the initial Recovery files but never completes the rest of the...
                    Yesterday, 08:54 AM
                  • kevinman
                    KD-55X9005A Vertical Stripes Right Side Mirrored Vertically At Start
                    by kevinman
                    Hi, TV boots with distorted image right side mirrored verticaly sometimes vertical stripes making off-on turns picture to normal and "perfect" (netflix image) that I highly doubt this is something related with t-con signal lines?? rather it looks software corruption bad mem chips voltage collapse or an intantaneous fault with fluctuating powerboard voltages?? As it happens usually when TV is cold sometimes fault comes back after a full day use should I check powerboard voltages with oscilloscope??
                    12-17-2023, 06:22 AM
                  • mopenstein
                    Looking for Vertical IC for RCA Chassis CTC159L CRT
                    by mopenstein
                    I'm working on my 27" RCA console TV built in 1990. It had some vertical rollover for a few months that went away after being powered on for a few minutes. I had been meaning to open it up and check it out but it had total vertical collapse before I could get to it.

                    Now that I have the time I opened it up and found a couple leaky capacitors around the vertical ic. So I figured the caps went bad and cooked the vertical IC.

                    I got the caps out and replacements on order. But when I took out the Vertical IC I saw that the chip numbers have been almost completely wiped...
                    09-24-2023, 10:41 AM
                  • x_orange90_x
                    TCL 50S535 bad tcon or panel issue?
                    by x_orange90_x
                    Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
                    03-29-2025, 11:02 PM
                  • Loading...
                  • No more items.
                  Working...