turning back for a little info i had a samsung LE37R88BD a few years ago and it developed a dark picture and ghosting fault, changed the T-Con out and the thing worked like new again and hasnt went faulty since. I have purchased another Samsung but this time model number is LE37R87BDhs thhe same fault. it is the exact same T-Con board that is in the TV so my question is will i have to purchase a new T-Con or can an existing one be repaired ?
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
T-Con Repair ?
Collapse
X
-
Re: T-Con Repair ?
Can we see the pictures of the board and the screen shot to see what the pictures you describe look like?Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809
-
Re: T-Con Repair ?
Can we see the screen shot of the picture so I can what the fault looks like?Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809
Comment
-
Re: T-Con Repair ?
Yep looks like an AS15 failure to me, to prove it you can test the gamma voltages on the T-con.
(I thought we had a quiet week for AS15's!)Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Comment
-
Re: T-Con Repair ?
On the left hand side of the T-con board you have a large block of test points marked VGAMA1 through VGAMA22.
Please take a measurement of each and post the result of each
e.g.
VGAMA1 - 0.05V
VGAMA2 - 0.5V
etc.
(The results will vary)Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Comment
-
Re: T-Con Repair ?
You have the red probe in COM and black in VOLT/OHM, it doesn't really matter but you should normally have the black probe in COM and red in VOLT/OHM.
(Just ignore the minus sign for the readings if you have made some already, it's not important.)Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Comment
-
Re: T-Con Repair ?
OK tom here goes
VGAMA1 : -15.47v
VGAMA2 : -15.34v
VGAMA3 : -13.56v
VGAMA4 : -12.36v
VGAMA5 : -11.50v
VGAMA6 : -10.89v
VGAMA7 : -10.53v
VGAMA8 : -10.24v
VGAMA9 : -9.97v
VGAMA10: -7.57v
VGAMA11: -7.39v
VGAMA12: -6.89v
VGAMA13: -6.93v
VGAMA14: -7.40v
VGAMA15: -7.46v
VGAMA16: -7.54v
VGAMA17: -7.63v
VGAMA18: -7.75v
VGAMA19: -7.87v
VGAMA20: -8.04v
VGAMA21: -8.54v
VGAMA22: -8.60v
Comment
-
Re: T-Con Repair ?
That was with black probe on the chassis, and with volt/ohm and COM the wrong way around?
If so the AS15 chip is bad... very common faultPlease do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Comment
-
Re: T-Con Repair ?
was looking at this one :http://www.ebay.co.uk/itm/AS15-F-AS1...item1e8ba3379f
it is AS15-F, do those other numbers need to match ?
Comment
Comment