Alba 32880hdf Flashing standby

[vinceroger69]

Re: Alba 32880hdf Flashing standby

did you unzip the files in the download?

[anotherdude]

Re: Alba 32880hdf Flashing standby

what EEPROM is on the main board?,maybee one that can be reset,using a pin to pin short,that might bring it back

listed as u162

schematic says NAND512-A


I can't make out the whole of the model number on the board as it's located under the expansion slot

[anotherdude]

Re: Alba 32880hdf Flashing standby

heres a picture or 2

[anotherdude]

Re: Alba 32880hdf Flashing standby

did you unzip the files in the download?

yes of course, It seemed to be going through it but i'm guessing me pulling the power (too early maybe) after no activity was the issue or incorrect firmware

[multimeter]

Re: Alba 32880hdf Flashing standby

^^ thats not an EEPROM ..

[vinceroger69]

Re: Alba 32880hdf Flashing standby

yes of course, It seemed to be going through it but i'm guessing me pulling the power (too early maybe) after no activity was the issue or incorrect firmware

whats the full main board number you need i will look in my box of boards tommorow also is there another source for the firmware maybe the member in the other thread who says he has it?

[anotherdude]

Re: Alba 32880hdf Flashing standby

whats the full main board number you need i will look in my box of boards tommorow also is there another source for the firmware maybe the member in the other thread who says he has it?

17mb62-1 v1

[anotherdude]

Re: Alba 32880hdf Flashing standby

^^ thats not an EEPROM ..

sorry my bad should of realised

can't seem to see it my eyes are pretty poor

can you see it here so i can take a photo just so i know which one to picture

[anotherdude]

Re: Alba 32880hdf Flashing standby

...........

[multimeter]

Re: Alba 32880hdf Flashing standby

only one i can see there is the 8 legged chip to the left of the yellow sticker,prob closet to the proccessor ,is that it ?,any part number,eeproms are normally 8 pin chips

[anotherdude]

Re: Alba 32880hdf Flashing standby

only one i can see there is the 8 legged chip to the left of the yellow sticker,is that it ?,any part number,eeproms are normally 8 pin chips

that is it, listed as serial flash?, missed it from the beginning

[multimeter]

Re: Alba 32880hdf Flashing standby

spi? flash chip part nu,starts like 24c******?

[multimeter]

Re: Alba 32880hdf Flashing standby

ahh,seen pic lol,try googling for a pin configuration,some you can short 2 pins,power tv on and remove shorts this reboots the eeprom,not on all though

[tom66]

Re: Alba 32880hdf Flashing standby

I have a 17MB62-2.6 with fried processor but OK firmware chips. I can send you the dud board for postage cost, perhaps you can make some use of the flash chips.

[anotherdude]

Re: Alba 32880hdf Flashing standby

ahh,seen pic lol,try googling for a pin configuration,some you can short 2 pins,power tv on and remove shorts this reboots the eeprom,not on all though

can't find anything from the model number in the picture

the schematic lists it as mx25l512

shows the pinout but no info on how to go about resetting them

[anotherdude]

Re: Alba 32880hdf Flashing standby

I have a 17MB62-2.6 with fried processor but OK firmware chips. I can send you the dud board for postage cost, perhaps you can make some use of the flash chips.

cheers tom, might take you up on that

[tom66]

Re: Alba 32880hdf Flashing standby

Just be aware my board is a FHD 32" LG panel, yours could be Samsung 32" 720p? Cannot guarantee F/W or panel settings will be compatible.

[anotherdude]

Re: Alba 32880hdf Flashing standby

Just be aware my board is a FHD 32" LG panel, yours could be Samsung 32" 720p? Cannot guarantee F/W or panel settings will be compatible.

thanks tom, be cheaper/easier to send me the chips if thats doable?

[tom66]

Re: Alba 32880hdf Flashing standby

Doesn't make much difference - the chips have the F/W on them for that set up -- now on some Vestels you can change panel settings, cannot confirm yours will be able to do this.

[vinceroger69]

Re: Alba 32880hdf Flashing standby

just had a look in my shed at all my main boards sorry but non match the number at all not even close.