Picked this up last night originally told stuck in standby (assumed just solid standby) but it flashes blue and red indicating a problem in the self check i think
Anyway measured the voltages from the psu to the mainboard and the only one that currently stands out is the 12v reads 11.7 not really much of a drop but only one i'm really noticing
BL inverter reads 25v which should be correct I think, tried the obvious disconnecting boards one by one etc
any suggestions?
Disconnected the main board and powered it up the 12v pin now reads 12.6v with the main board disconnected, points to a main board fault?
edit2: looking through the 17pw25-4 schematic there is a 24v aud pin on PL805 but i read nothing at this pin when not connected to the main board, also the same when main board is connected
Anyway measured the voltages from the psu to the mainboard and the only one that currently stands out is the 12v reads 11.7 not really much of a drop but only one i'm really noticing
BL inverter reads 25v which should be correct I think, tried the obvious disconnecting boards one by one etc
any suggestions?
Disconnected the main board and powered it up the 12v pin now reads 12.6v with the main board disconnected, points to a main board fault?
edit2: looking through the 17pw25-4 schematic there is a 24v aud pin on PL805 but i read nothing at this pin when not connected to the main board, also the same when main board is connected
Comment