Finlux 32FLD760P with Vestel 17PW20.v1

Collapse
X
Collapse
 
  • Page of 10
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 4 5 6 7 8 9 10 template Next
  • tom66
    EVs Rule
    • Apr 2011
    • 32560
    • UK
    #181
    Re: Finlux 32FLD760P with Vestel 17PW20.v1

    That is normal. If the TV detects an error when it does that power on check, it won't power up properly.
    Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
    For service manual, schematic, boardview (board view), datasheet, cad - use our search.

      Comment

      • Tristo
        Member
        • Apr 2013
        • 13
        • UK
        #182
        Re: Finlux 32FLD760P with Vestel 17PW20.v1

        Thanks for your help Tom.
        I guess I should forget about the power supply board and start looking elsewhere.
        Im guessing the flashing LED is a fault code, but will probably end up costing much more than the power board.
        Thanks again

          Comment

          • tom66
            EVs Rule
            • Apr 2011
            • 32560
            • UK
            #183
            Re: Finlux 32FLD760P with Vestel 17PW20.v1

            What you should try is disconnecting the connector with the thin wires on it (PL803), then wire a 1k resistor from that to the 5V standby, on pin 12 of PL812.

            Then see if the voltages are stable, with the main board connected.

            Then, connect pin 1 of PL803 to 5V standby through a 1k and see if backlight lights up and is good, check if voltages are stable.
            Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
            For service manual, schematic, boardview (board view), datasheet, cad - use our search.

              Comment

              • cossiejay
                Senior Member
                • Nov 2010
                • 83
                #184
                Re: Finlux 32FLD760P with Vestel 17PW20.v1

                sorry to highjack this thread can someone please advice me if I can use the 17pw20 v1 rather then the v2 after reading this seems to be much easier to replace the board

                  Comment

                  Previous 1 2 3 4 5 6 7 8 9 10 template Next

                  Related Topics

                  Collapse
                  • piernov
                    Finlux 65-FUC-8060 firmware request (Vestel 17MB130S 23473048 VES650QNTS-2D-U11)
                    by piernov
                    Hi,
                    Got a Finlux 65-FUC-8060 TV that doesn't turn on, 5V standby present from PSU, 3.3V on mainboard present, button signal gets pulled low when pressed, but mainboard never sends signal to PSU to turn main rails on.
                    I suspect corrupt firmware but I haven't been able to find anything for this TV.
                    TV model: Finlux 65-FUC-8060
                    Mainboard: Vestel 17MB130S 23473048
                    Panel: VES650QNTS-2D-U11

                    At the very least looking for a firmware that can make it turn on to confirm the problem, and hopefully a firmware that's compatible with the panel.
                    06-01-2024, 12:57 PM
                  • cstout
                    DeLonghi AC Remote only accepts 3V
                    by cstout
                    Hello all, I've been looking into this portable air conditioner's remote control and can't find what could be causing the problem - or possibly this remote is just terribly designed.

                    The remote only works at exactly 3V - if I drop it any lower, using my bench power supply, to say, 2.9V then the remote will not flash the display and turn off. I don't have any AAA batteries that are exactly 1.5V each so I'm not sure if this remote is designed this way - to only use the freshest possible batteries, or if there's a failed component in the mix.

                    I can't find any schematics...
                    06-03-2024, 03:53 PM
                  • Mc_Millian
                    Toshiba 50lf711u20 fire tv remote not pairing
                    by Mc_Millian
                    Hello everyone,

                    I was wondering if anyone could help my in pairing a remote with a Toshiba fire tv?
                    The Tv model number is: 50lf711u20 Rev B.


                    I've already replaced all the the circuit boards within the tv along with the I.R. sensor receiver.

                    I've tried 3 different remotes which should be fully compatible with this TV.


                    Oddly enough. A few if the buttons on all of the remotes actually work. Even without pairing...which makes no sense.

                    The power button, along with the volume,back,select, and directional...
                    04-07-2022, 12:15 PM
                  • edugimeno
                    HiSense 55A7500F won't obbey to remote after power on
                    by edugimeno
                    Hi! I have this TV set that does the following:
                    1) I press the red power button on the remote
                    2) The TV turns on normally
                    3) After that it won't take any other command from the remote, neither power off, volume, channel, NOTHING
                    4) We need to either pull the main cable or use the built in button at the bottom to select funcion OFF

                    Then after it's off, it would again accept the TURN ON from the remote and same again

                    BUT:
                    -The remote does show the correct IR beam while observed thru a phone camera
                    -The TV works fine while using the MiRemote...
                    03-14-2023, 11:22 AM
                  • tmhobadcap
                    Pioneer VSX-522-K remote control not working???
                    by tmhobadcap
                    I have this receiver for at least 10 years. Usually, we just use the remote for turning on/off and adjusting the volume. Recently, the remote control started not able to turn the receiver on. Later, the volume also could not be adjusted by the remote control.

                    At first, I thought that it was the usual problem which can be fixed by cleaning the contacts on the switches and the pcb. I opened the remote and clean it with alcohol. The remote did work again after that. But after one day, it did not work again. I opened it again and clean with alcohol and contact cleaner. Again it worked...
                    12-24-2020, 01:44 AM
                  • Loading...
                  • No more items.
                  Working...