Sanyo CE32LD47-B flashing standby light

[selldoor]

Re: Sanyo CE32LD47-B flashing standby light

Unlikely to be anything but check this for bridging.

[blib]

Re: Sanyo CE32LD47-B flashing standby light

Thanks for all the replies.Any thoughts on why the PS runs with main board disconnected?

[blib]

Re: Sanyo CE32LD47-B flashing standby light

Tom how did you know that this is a 17MB35? Did you just recognise it? Have ordered one on ebay model specific but could have paid a lot less.Could not see those numbers anywhere on the board.

[tom66]

Re: Sanyo CE32LD47-B flashing standby light

Tom how did you know that this is a 17MB35? Did you just recognise it? Have ordered one on ebay model specific but could have paid a lot less.Could not see those numbers anywhere on the board.

Far, far too much experience with shitty Vestel TVs

They are model specific, but they can be programmed easily. Worst case you usually get a wrong colour image due to panel settings being wrong; you can use 4725-MENU (on remote) to access service menu and reprogram it.

[blib]

Re: Sanyo CE32LD47-B flashing standby light

Ok update on this one.Just fitted replacement main board and the symptoms are just the same.I suppose its the power supply then.

[blib]

Re: Sanyo CE32LD47-B flashing standby light

Fitted replacement power board and set is now working.I think the clue to this one all along was the fact that the power supply would run without the main board connected.Hope this helps anyone else who has this fault.

[tom66]

Re: Sanyo CE32LD47-B flashing standby light

Very odd one... Thanks for posting back the fix.