test active pfc power with lamp test

[khelane]

Hello
I have a big problem and that is that in some cases when repairing active pfc power supplies I cannot work with a test lamp. I can only get help with 5 volts standby and for starting and starting I have to work without a lamp and this way there is a possibility of parts exploding and other parts being added.
Sometimes with a multimeter test the problems can be reduced to some extent, but I had several cases that had to be tested on and online and recently two varistors exploded. They had terrible resistance because the power supplies were over 800 watts.
Is there a way to safely test these active pfc power supplies?
Thank you

[stj]

use a bigger lamp, i use a 400W halogen floodlamp
another guy on the forum uses a water heater or a toaster or something like that!!

[khelane]

tnx

[CapLeaker]

Or multiple incandescent lamps to increase wattage.

[khelane]

Thank you for your advice.
The main problem is that when I turn on the device with the test lamp, the lamp quickly turns off and on, and I don't know if there is a connection in the circuit or not. When the hot part has a connection, the lamp turns on completely, but after testing and troubleshooting, I want to start the device with the test lamp, it turns off and on quickly, and I'm afraid that if I turn on the test lamp, it will explode. A few days ago, I repaired a device. The lamp blinked or turned on and off during startup and startup. When I started it with the main power, the varistor exploded.
In normal power supplies, the test lamp has no problem with starting the power and turning on, but in active pfc power supplies, when I turn it on with the test lamp, if there is a connection in the hot part, the lamp turns on completely as before, but when there is no connection or maybe a component has a leak, after turning on and testing the output voltages, the test lamp quickly turns off and on. Is this turning on and off my problem?