i recently recapped a MSI 815EPT Pro (Version 5 ; MS-6337) board i accidentially bought on ebay for 1€ *lol*
all VRM caps popped (Lelon RXA 1500uF 10V) and almost all other caps (Chhsi HK 6,3V 1000uF ... EVERYWHERE!
) were at least bulging and most of them popped. some caps were already leaking onto the board and the electrolyte kinda destroyed the pcb surface..
i tried to turn the board on (without CPU, RAM, gfx-card, ...) only with a crappy cheap ass ATX PSU (Casecom "Model: 420Watt" .. actually 240W and weights less than a DVD-ROM drive lol)
wouldnt even power on.. completely dead.
unfortunately i didnt take pics before recapping...
i replaced all Lelon Caps with Panasonic FJ series (6,3V 2200uF) and all other caps (factory: Chhsi) with Rubycon MBZ 6,3V 1800uF
tested the board again after the recap... and it POSTed fine and was rock solid again
i just took a few pics .. they're not so good cause its night here (3:00 AM now)
RAM Caps
damaged PCB (because of Lelon caps)
Celeron 1,2GHz (Tualatin) to be replaced by a Tualatin PIII ; MBZs at the RAM slots and Pannys at the bottom left
RAM Slot Pannys
hope this lasts a bit longer
all VRM caps popped (Lelon RXA 1500uF 10V) and almost all other caps (Chhsi HK 6,3V 1000uF ... EVERYWHERE!

i tried to turn the board on (without CPU, RAM, gfx-card, ...) only with a crappy cheap ass ATX PSU (Casecom "Model: 420Watt" .. actually 240W and weights less than a DVD-ROM drive lol)
wouldnt even power on.. completely dead.
unfortunately i didnt take pics before recapping...

i replaced all Lelon Caps with Panasonic FJ series (6,3V 2200uF) and all other caps (factory: Chhsi) with Rubycon MBZ 6,3V 1800uF
tested the board again after the recap... and it POSTed fine and was rock solid again

i just took a few pics .. they're not so good cause its night here (3:00 AM now)

RAM Caps
damaged PCB (because of Lelon caps)
Celeron 1,2GHz (Tualatin) to be replaced by a Tualatin PIII ; MBZs at the RAM slots and Pannys at the bottom left
RAM Slot Pannys
hope this lasts a bit longer

Comment