I have an old Samsung display that the CCFLs broke in. I decided to go the route of converting to LED instead of ordering new CCFLs and installing. At this point in time I have the board wired to the PSU's output pins to the display board. I found a 13.8V source (LED inverter shows that it needs 10-30V), and a ground, as well as outputs silkscreened to say:
EVA (Could be EUA)
DET
ADJ
My assumption is that Dimm would be jumped to ADJ and On would be jumped to DET.
I got everything wired up and turned on, and the LEDs flash momentarily and the PSU seems to shut off. I'm not sure if the LED inverter is drawing too much current from the 13.8V pin that I'm using. Any assistance would be greatly appreciated, the monitor runs fine without the LED driver installed.
EVA (Could be EUA)
DET
ADJ
My assumption is that Dimm would be jumped to ADJ and On would be jumped to DET.
I got everything wired up and turned on, and the LEDs flash momentarily and the PSU seems to shut off. I'm not sure if the LED inverter is drawing too much current from the 13.8V pin that I'm using. Any assistance would be greatly appreciated, the monitor runs fine without the LED driver installed.
Comment