No it is common anode only (+ve is common). I put red probe on 1 and black on other 3 and the corresponding LED lights up...

I recieved the led but it's pinout is different. Size is exactly the same however I searched many brands, but all have the same pinout (as in attached picture). What this controller uses is 1+, 4 R-, 3 G-, 2 B- . It's like if I place it upside down the pinout matches. I don't know why the manufacturer didn't choose standard pinout. 😔

Does anyone know such an LED?...

I ordered some 0.2W RGB 3528 package. I couldnt find anything else on local sites. Let's see...

Yes I am planning to change all 4. Do you know what wattage it is?...

I have a nacon controller which has some fancy RGB ring (4 RGB LEDs). 3 of 4 leds are not good and I am looking for a replacement. The size I measured is 3mm x 2.5mm and it seems a 3528 led would fit fine, and it's in common anode. But I am not sure what wattage it is. I have attached photos of led and driver ic (ak63rq1 I think).

Also one of the triggers is malfunctioning sometimes, I don't know what these pots are called. I measured across the 1st and last legs (in circuit) seems to be 1.1kohm pot. I found some xbox controllers have this but they are 10k. Any info?...

Ok so that's 47ohm I think. thankyou very much

Hi everyone,

Can someone look up this resistor value on an SAE-004 motherboard please.

[url]https://youtube.com/shorts/ioO8PjarQQI?feature=shared[/url]

Thanks in advancehttps://Hi everyone,<br /> <br /> Ca...nks in advanceHi everyone,

Can someone look up this resistor value on an SAE-004 motherboard please.

[url]https://youtube.com/shorts/ioO8PjarQQI?feature=shared[/url]

[ATTACH=JSON]{"data-align":"none","data-size":"full","title":"Screenshot_20240527-211412~2.png","data-attachmentid":3278975}[/ATTACH]

One contact leg of the button should be that via marked in yellow and the other contact to ground plate. I believe that via is still ok from the photo. You can check the voltage on it to confirm.



​​​​​​...