Not really sure if it's the right place to post this, but here's something very strange. I got a brand new audio cassette out of its plastic packaging, put it in my recorder, and recorded a radio programme onto it. The programme didn't fill the tape, but the next episode wouldn't fit on that side as well - so I decided to fast forward to the end so I could use side B.
This particular tape recorder has a search function. That is, if it 'hears' a signal on the tape after a long silence while you're fast forwarding, it'll stop there and play the tape.
Shortly before the end of the tape was reached, the recorder stopped forwarding and started playing. I heard a low, wavering buzz coming out of the right speaker for about 8 seconds, then it cut off. Rewinding the tape a bit, I discovered that the noise was actually on the tape itself, not from the equipment.
This tape is brand new and has never been recorded (or even played) before, except for that radio programme that used up part of one side. The area with the buzz had never been recorded before!
Do factories sometimes put signals onto obscure areas of the tape for testing purposes, before sending them out to shops? If it hadn't been for the search function of my tape recorder, I never would have noticed and probably would have recorded over it later on!
Here's a recording of the sound, if you're interested:
http://tomsonic.dyndns.org/temp/tapenoise.MP3
This particular tape recorder has a search function. That is, if it 'hears' a signal on the tape after a long silence while you're fast forwarding, it'll stop there and play the tape.
Shortly before the end of the tape was reached, the recorder stopped forwarding and started playing. I heard a low, wavering buzz coming out of the right speaker for about 8 seconds, then it cut off. Rewinding the tape a bit, I discovered that the noise was actually on the tape itself, not from the equipment.
This tape is brand new and has never been recorded (or even played) before, except for that radio programme that used up part of one side. The area with the buzz had never been recorded before!
Do factories sometimes put signals onto obscure areas of the tape for testing purposes, before sending them out to shops? If it hadn't been for the search function of my tape recorder, I never would have noticed and probably would have recorded over it later on!
Here's a recording of the sound, if you're interested:
http://tomsonic.dyndns.org/temp/tapenoise.MP3
Comment