Samsung LN46D630 no picture

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • Bloup101
    Member
    • Mar 2019
    • 15
    • Canada
    #21
    Re: Samsung LN46D630 no picture

    Sorry obviously I meant the main to the power board. It would be impossible for the backlight to flash with the inverter board disconnected.

      Comment

      • Bloup101
        Member
        • Mar 2019
        • 15
        • Canada
        #22
        Re: Samsung LN46D630 no picture

        Here's a pic of PFC IC ICP801
        Attached Files
        Last edited by Bloup101; 06-15-2019, 07:45 PM.

          Comment

          • Bloup101
            Member
            • Mar 2019
            • 15
            • Canada
            #23
            Re: Samsung LN46D630 no picture

            I took caps CM809 and CM811 off the board but trying to test them with my my DMM without the capacitor mode is difficult. Sometimes no readings or all over the place.

              Comment

              • Bloup101
                Member
                • Mar 2019
                • 15
                • Canada
                #24
                Re: Samsung LN46D630 no picture

                Here's the ICP801 FAN7930B pin out, what is the testing procedure? The power board is out of stock on jimmy...
                Attached Files
                Last edited by Bloup101; 06-15-2019, 07:54 PM.

                  Comment

                  • budm
                    Badcaps Legend
                    • Feb 2010
                    • 40746
                    • USA
                    #25
                    Re: Samsung LN46D630 no picture

                    Remove the board so you can test the board by itself but you MUST be careful since you will be working in the HOT DEALY side of the circuit so you should at least power the board from GFCI outlet in case you make body contact with the board, you will use 470 up to 1K 1/4W resistor between the Standby power supply output pin and the PS-ON pin then power up the board and see what Voltage you have on VCC pin and the GND pin.
                    BTW: Make sure to put the parts you remove back in correctly before doing the test.
                    Last edited by budm; 06-15-2019, 09:26 PM.
                    Never stop learning
                    Basic LCD TV and Monitor troubleshooting guides.
                    http://www.badcaps.net/forum/showthr...956#post305956

                    Voltage Regulator (LDO) testing:
                    http://www.badcaps.net/forum/showthr...999#post300999

                    Inverter testing using old CFL:
                    http://www.badcaps.net/forum/showthr...er+testing+cfl

                    Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                    http://s807.photobucket.com/user/budm/library/

                    TV Factory reset codes listing:
                    http://www.badcaps.net/forum/showthread.php?t=24809

                      Comment

                      • Bloup101
                        Member
                        • Mar 2019
                        • 15
                        • Canada
                        #26
                        Re: Samsung LN46D630 no picture

                        I found a used power board, problem fixed, thank you.

                          Comment

                          • neilc6
                            Badcaps Legend
                            • Nov 2015
                            • 1550
                            • Canada
                            #27
                            Re: Samsung LN46D630 no picture

                            Just repaired this model. Symptom - turns on and off with chimes but no backlight. Alligator clips on big caps show PFC going to about 250VDC on power on and shutting down quickly. Both fuses F801S and F802S test good and not open. Film cap CI818 tests good in circuit and not bulging on side. DP810 tests good in circuit with multimeter in diode mode. CP820 no reading in circuit and out of circuit measures as a resistor. Replaced with 220pf/3kv spare I had from previous repair and tv is fixed.

                              Comment

                              • KONKAVE
                                New Member
                                • Dec 2020
                                • 1
                                • United States of America
                                #28
                                Re: Samsung LN46D630 no picture

                                Solved here: I just had an LN46D630 come in with no backlight. Has power, and audio, but no backlight. I replaced CP809, CP810 and CP820. It has been powered on for 24 hours, with a few power cycles.

                                  Comment

                                  Previous 1 2 template Next

                                  Related Topics

                                  Collapse
                                  • Document Archive
                                    Samsung Galaxy Book 2 Notebook Specification for Upgrade or Repair
                                    by Document Archive
                                    This specification for the Samsung Galaxy Book 2 Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Galaxy Book 2 boardview and Galaxy Book 2 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...
                                    09-07-2024, 05:50 AM
                                  • TR103
                                    Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
                                    by TR103
                                    Hi, I have a Samsung UE50TU with:
                                    - sound and backlight, but no picture
                                    - when it arrived, it had a picture for a few seconds
                                    - it keeps rebooting
                                    - without ribbon cable between the two panel boards, it does not reboot but I have no picture
                                    - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
                                    - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

                                    - without cable between mainboard and lcd panel and with a jumpered...
                                    01-22-2025, 04:12 PM
                                  • JJAAMM
                                    SAMSUNG UN55KS9000F picture fades then distorts into vertical lines after 20 seconds
                                    by JJAAMM
                                    This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.

                                    Problem
                                    TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode...
                                    07-06-2023, 06:01 AM
                                  • Mgiffune
                                    Samsung UN60EH6000F Black Screen, Backlight and Sound Good. Power Cycle Returns Picture
                                    by Mgiffune
                                    I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.

                                    I ordered a supposedly ‘new' Tcon board this time, and                                    ...
                                    06-09-2024, 10:28 AM
                                  • Dodgethis
                                    Samsung QN75Q6DRA, No Picture, Has BL, and Sound
                                    by Dodgethis
                                    Hello all,

                                    This is my first post, but long term lurker on the form learning as much as possible about these TV's. I was given this TV as due to a power outage of constant On/off of power to TV. The TV originally would just click on and off (Typical Reboot Cycle). I opened the back of the TV, and troubleshooted by taking the 96 pin LVDS off one at a time to see if I had a picture on either side. I finally fixed the reboot cycle by finding the error on the left side of the screen off connector CN 1301, and the TV would stay on. Further troubleshooting led me to the driver boards where...
                                    5 Photos
                                    09-11-2024, 07:39 AM
                                  • Loading...
                                  • No more items.
                                  Working...