55ub850v no picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • thuss
    Badcaps Veteran
    • Jul 2012
    • 321
    • uk

    #21
    Re: 55ub850v no picture

    I tried it with a different tcon (same model number as original) still no picture.

    Must be a faulty screen.

    Has anyone repaired one of these panels? A couple of the surface mounted caps on the ribbon tab boards gave continuous beeps.

    Comment

    • mmartell
      Badcaps Legend
      • Oct 2013
      • 3189
      • Canada

      #22
      Re: 55ub850v no picture

      Yes people have made repairs to those boards. What have you got to lose ? Try removing the suspect shorted cap(s).

      Comment

      • thuss
        Badcaps Veteran
        • Jul 2012
        • 321
        • uk

        #23
        Re: 55ub850v no picture

        no luck with the repair

        Comment

        Related Topics

        Collapse

        • maneatingmonkey
          Missing LCD Panel Voltages VGH, VGL, VCOM (TCL 55P6US Sound & Backlight but NO Picture)
          by maneatingmonkey
          I have a TCL 55P6US with sound and backlight but no picture. This model does not have a T-CON board, and the right (rear perspective) panel board is fed from the left panel board. I have not been able to induce any change by disconnecting the secondary panel board or the tape cut-off method on the primary board.

          There are a bunch of voltages missing on the panel boards. I can't find any shorted caps of the panel boards, and all of the missing voltage rails read in the kiloohms, which leads me to suspect the issue may lie on the circuit board, rather than a short in the panel.
          ...
          03-27-2024, 07:17 AM
        • EazyBone
          Sony XR-77A80J OLED 5 Blink
          by EazyBone
          Another eazybone post took on this OLED now.

          Symptoms. Hit power, white light shows briefly and then 5 blink red code. TCON issue per chart on first picture.

          I'm thinking I have a power board issue though, which is one of the options

          Now to check pin voltages from PSU to main and PSU to tcon

          Pic 2

          1 tcon on 12 -- 0v (when I hit power this goes to 3.1 stays for short time and back to zero)
          2 bl err -- 0.16
          3 evdd on --0
          4. Ac off det 3.187
          5 power on -- 3.362 BUT fluctuating randomly to 3.352
          6 stby...
          10-24-2023, 09:09 PM
        • x_orange90_x
          TCL 50S535 bad tcon or panel issue?
          by x_orange90_x
          Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
          03-29-2025, 11:02 PM
        • Tr0ll
          T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
          by Tr0ll
          Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

          The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

          Original T-con:
          Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

          First replacement T-con:

          I thought it might be t-con and ordered new t-con from china(supposedly tested)...
          10-07-2023, 07:48 PM
        • JJAAMM
          SAMSUNG UN55KS9000F picture fades then distorts into vertical lines after 20 seconds
          by JJAAMM
          This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.

          Problem
          TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode...
          07-06-2023, 06:01 AM
        • Loading...
        • No more items.
        Working...