Tcon or bad panel or other!!!????

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • fharris1977
    Senior Member
    • May 2017
    • 132
    • United States
    #1

    Tcon or bad panel or other!!!????

    Hello. I have an RCA lcd tv and after I replaced the power supply, the screen comes on but I have 2 large vertical black lines going down the right side of the screen (Picture is included) I then changed the t-con board and I still get the same 2 black lines. They may be slightly larger with the new t-con board. Did I get a defective t-con board or is it a bad panel or something else? I do recall bad caps on a power supply on a samsung flat screen caused multicolored lines all over the screen. If anyone has experienced this problem please help me out. Thanks in advance.
    Attached Files
    Last edited by fharris1977; 10-30-2017, 05:16 PM.
    Tags: None
    • koka0011
      Member
      • Apr 2013
      • 30
      • Sri Lanka
      #2
      Re: Tcon or bad panel or other!!!????

      cof ic fault.may be loose connection

        Comment

        • geeforce
          Senior Member
          • Oct 2017
          • 87
          • Canada
          #3
          Re: Tcon or bad panel or other!!!????

          TAB Bonds?... open up frame and apply pressure above the lines... or search up tab bonds etc

            Comment

            Previous template Next

            Related Topics

            Collapse
            • kca
              LG 82UN8570AUD ~ TCON or PANEL?
              by kca
              Hello all ~

              Hope this finds you well. This LG 82UN8570AUD (April 2021 model) 4K UHD television has full audio capabilities but video is compromised / problematic.

              When I picked up this large LG tv it had a full black screen upon startup. Previous owner said it just went black one day. No popping sound or anything else of note.

              I got the display to work by taping off several traces of the right-hand side ribbon cable on the TCON that leads from TCON to PANEL. However, despite dozens and dozens of attempts to find the right combination / range of traces taped...
              08-31-2025, 06:38 AM
            • x_orange90_x
              TCL 50S535 bad tcon or panel issue?
              by x_orange90_x
              Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
              03-29-2025, 11:02 PM
            • Daren87
              Sony 8K XBR-75Z8H White Screen Vertical Bars Tcon Code. Help Needed🙏
              by Daren87
              Hello everyone,

              I've recently been given a Sony 8k Z8H. It's got a white screen with two vertical black bars. At times it's given me the 5 blink Tcon code. Testing voltage on the Tcon I can see some low or missing voltage. I've done a basic visual check of cables and the COF. Not seeing anything obvious. The original Tcon seemed to have good caps until turning it over. On the bottom I found maybe 10 caps with both sides of the caps shorting to ground. I thought ok these caps and likely other components on the Tcon are shorted so let's try a replacement Tcon. I just received the...
              08-13-2023, 03:25 PM
            • netgearnetgear
              TCL 43S423 TCON OR PANEL FAULTY???
              by netgearnetgear
              Good day, I have a TCL TV: Model 43s423. After turning ON the TV, the ROKU TV logo appears with fine lines over the whole screen, then after a while there are vertical bands in the middle of the screen top to bottom and the TV tries to update its firmware but I do not have the remote to connect it to my new network connection. Also the Power ON light blinks 2 times in quick succession. When I remove the ribbon on the right of the tcon board the left side of the screen shows but with fine lines. If I remove the left side ribbon and connect the right side ribbon the whole screen is blank with...
              08-20-2025, 06:04 PM
            • howardc64
              Samsung QN75Q6FNA backlight no display, red LED blink 2x, fault in panel
              by howardc64
              • Prior owner tried a replacement main board. No difference.
              • Samsung 2x red blinking standby LED = panel fault
              • Jumpered FB_TRDY_1 (pin 1 CN1300 left. main tcon->left side buffer boards) and FB_TRDY_3 (pin 95 CN1301 right. main tcon->right side buffer boards) This allows testing individual T-Con (on main board) connection to panel on this Samsung. Found fault on left side (viewing from rear of TV)
              • Each side has 2 buffer boards, disconnected left side flex between 2 buffer boards. Fault is on the left most board.
              • Tape masking eventually isolated to CN1300 pin 15 (CKV4_GOA) Display
              ...
              07-19-2025, 10:54 PM
            • Loading...
            • No more items.
            Working...