Sony bravia kdl26ml130 no remote signals pics this time

[manstoblame]

Re: Sony bravia kdl26ml130 no remote signals pics this time

There should be a diagram for the HMI board (control panel).
http://www.shopjimmy.com/sony-a-1268...-hm1-board.htm

Budm here you go this is all I have

[budm]

Re: Sony bravia kdl26ml130 no remote signals pics this time

BTW, there is the Remote IR board that you need to check, the HMI board is the button board which you said it function but not the remote function.
http://www.shopjimmy.com/sony-a-1268...-hm3-board.htm

[CapLeaker]

Re: Sony bravia kdl26ml130 no remote signals pics this time

first make sure the remote is putting IR out! If that's good, then proceed to the IR board on the TV. Most of the time there is a ceramic SMD cap on the IR board that is shorted to GND, or a bad IR sensor itself.

[budm]

Re: Sony bravia kdl26ml130 no remote signals pics this time

There should be a diagram for the HMI board (control panel).
http://www.shopjimmy.com/sony-a-1268...-hm1-board.htm

[manstoblame]

Re: Sony bravia kdl26ml130 no remote signals pics this time

Are those two resistors (it is more likely supposed to be ferrite bead small value inductor), as long as it shows as <1 Ohms it is OK. So do they show as open circuit? I doubt that they are bad due to very small current flow through them.
The 0.01uF cap, is it bad? you can use 0.01uF CERAMIC CAP.
How about the diagram for the KEY pads connected to trust connector?

The first image on the bottom part of the connector has three connect points for the manual key pad I believe it's ground the power initiate and key 1 pins 9,10,11 about the 0.01 uf it reads 3.3v if I understand right.

[budm]

Re: Sony bravia kdl26ml130 no remote signals pics this time

Are those two resistors (it is more likely supposed to be ferrite bead small value inductor), as long as it shows as <1 Ohms it is OK. So do they show as open circuit? I doubt that they are bad due to very small current flow through them.
The 0.01uF cap, is it bad? you can use 0.01uF CERAMIC CAP.
How about the diagram for the KEY pads connected to that connector?

[manstoblame]

Same problem as before where as I can turn set on and change channels manually but get no action with the remote. The parts list shows what the ratings are for the resistors used arrows point to them also included is a diagram showing where things connect I guess you call it a pinout not sure anyway just wondering if the resistors can be replaced with a simple jumper wire? They're all 0 (micro Henry) as i have been told. Other ideas are needed asap if more images are need I now know how to use this Android tablet so just ask I need help please