Pioneer PDP-435PU, no picture after 10 seconds

[beurjean]

Hello I have the following problem. When I make the room dark and I see something I lit him with a big black blur in the middle turn on the TV and text that can not be read at the top left corner. This he hold a full 10sec and then falls back to black screen.

Voltage on the power supply is good. There should be 215 volts to go from the power board? Drive to the x-and y-drive This comes on the second count, but then falls back to 10volt very quickly.

The capacitors look good on the eye. I did not know much about TVs and measuring components but would like to learn from and fix the problem here.

http://s3.amazonaws....43_img_0793.jpg

[beurjean]

Re: Pioneer PDP-435PU, no picture after 10 seconds

can everyone read this text or is it a bad translation

[philliesfan30m]

Re: Pioneer PDP-435PU, no picture after 10 seconds

pic isn't found and if you tried to turn a pioneer tv on with the back cover off they have a protection switch which will put it into a protect mode and you have to reset it with the original remote. i personally don't understand what you are saying about a blur or blotch in the screen might be a bad panel. take pictures of the fault and of the whole back of the tv with the cover off and each individual board so we can see them.

[RJARRRPCGP]

Re: Pioneer PDP-435PU, no picture after 10 seconds

http://s3.amazonaws....43_img_0793.jpg

Looks like a typo on your link.

[Fred53]

Re: Pioneer PDP-435PU, no picture after 10 seconds

Found this on a dutch site http://www.sat4all.com/forums/ same user name

link typo correct URL for picture.

http://s3.amazonaws.com/f01.justansw...3_img_0793.jpg

[beurjean]

Re: Pioneer PDP-435PU, no picture after 10 seconds

I have no remote control.

I only see a black screen light up for 10 seconds.

And in the upper left corner a text what i can't read.

There must be 215 volt on the x and y-drive.

The 215 volt allows 10 seconds on the x and y-drive.

but falls very quickly back to 8 volts.

http://s3.amazonaws.com/f01.justansw...3_img_0793.jpg

[paulstef]

Re: Pioneer PDP-435PU, no picture after 10 seconds

Any flashing red or green LED on the panel or media unit once it turns off?

[beurjean]

Re: Pioneer PDP-435PU, no picture after 10 seconds

The Green and the Red led burns

[paulstef]

Re: Pioneer PDP-435PU, no picture after 10 seconds

The Green and the Red led burns

You do have the service manual, right? At what intervals do they turn on/off? How often? Or are both constantly on??

[beurjean]

Re: Pioneer PDP-435PU, no picture after 10 seconds

I have the service manual from internet.

When i turn on the tv the green led at the front is on

And the red en green led at the media unit ar both constantly on.

When the tv turns off the red led at the front is on (constantly)

And the red led at the media unit is on. (constantly)

I don't have a media reciever i'm using a ps3

[paulstef]

Re: Pioneer PDP-435PU, no picture after 10 seconds

Found this one too. Field service guide for your plasma TV.