philips 42PFP5532D stuck on standby

[ACsellers]

Hi I have a philips 42PFP5532D which is stuck on standby and the power LED flashes 1 long flash then 4 short ones, then 1 long and 5 short, then 1 long and 2 short? Does anyone know the problem? Does anyone know any blinking codes for TVs??

[tom66]

Re: philips 42PFP5532D stuck on standby

What's the chassis code - printed on rear of set for example Q599.3E-LA? Next to normal model number.

[ACsellers]

Re: philips 42PFP5532D stuck on standby

Hi tom66 Where would I find the Chassis code? I have the serial and model number but nothing saying the Chassis code

[tom66]

Re: philips 42PFP5532D stuck on standby

Can you provide a picture of the back model number label?

[ACsellers]

Re: philips 42PFP5532D stuck on standby

Hope this helps

[vinceroger69]

Re: philips 42PFP5532D stuck on standby

not sure if tom has this but im sure this is the correct link

[tom66]

Re: philips 42PFP5532D stuck on standby

Yes chassis is LC7.2E-PA.

So this is a plasma?

[ACsellers]

Re: philips 42PFP5532D stuck on standby

Yeah it is

[tom66]

Re: philips 42PFP5532D stuck on standby

Here's exact manual


Error codes page 18.

error code 4: General I2C error
error code 5: Trident video processor error
error code 2: +12V low/missing

I'd focus on error code 2. It looks like it could cause the other two errors. Check +12V at PSU.

[ACsellers]

Re: philips 42PFP5532D stuck on standby

IS this toms-service-manual your website? Can I just generally browse through it for other TVs?

[tom66]

Re: philips 42PFP5532D stuck on standby

IS this toms-service-manual your website? Can I just generally browse through it for other TVs?

Yes, and yes.
http://www.toms-service-manuals.com/
http://www.tgohome.com/ServiceManuals/

[ACsellers]

Re: philips 42PFP5532D stuck on standby

Cheers top lad!

[ACsellers]

Re: philips 42PFP5532D stuck on standby

Well with most likely it being the +12V protection error code is that a fault on the power supply board? Is it a certain component or just a whole board change?

[tom66]

Re: philips 42PFP5532D stuck on standby

It probably indicates a fault with the 12V out of the power board, but there's also the chance the main board is shorted. Also possible the main board is mis-detecting the fault and there actually isn't one (I've had this before.)

To find exact fault, it's best to check the 12V from the power supply just as the set is turned on. If it's low, then that points to a fault in the first two categories. If not, it's in the latter category.