sony kdl 32 bx 300 turns off and back on help

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ivtec
    Badcaps Legend
    • Dec 2008
    • 1967
    • USA

    #1

    sony kdl 32 bx 300 turns off and back on help

    Hi my old Sony i turn it off and it turns itself back up and many times remote wont work have to unplug tv
  • CapLeaker
    Leaking Member
    • Dec 2014
    • 7972
    • Canada

    #2
    Try a factory reset or self test.
    service manual here : https://servicemanuals.us/sony/tv/kd...l-32bx300.html
    Maybe the firmware is corrupted or the flash going bad? Take the batteries out of the remote and see if this new found magic stops.

    Edit: read this old thread: https://www.badcaps.net/forum/troubl...ndefined-state
    Last edited by CapLeaker; 07-07-2024, 01:16 PM.

    Comment

    • ivtec
      Badcaps Legend
      • Dec 2008
      • 1967
      • USA

      #3
      Originally posted by CapLeaker
      Try a factory reset or self test.
      service manual here : https://servicemanuals.us/sony/tv/kd...l-32bx300.html
      Maybe the firmware is corrupted or the flash going bad? Take the batteries out of the remote and see if this new found magic stops.

      Edit: read this old thread: https://www.badcaps.net/forum/troubl...ndefined-state
      Thanks mate. It's funny that i took the back cover out and while was out tv worked fine. Also i put the Tv in my storage and today went to try to turn it on and off and so far it did not turn on by itself .
      Last edited by ivtec; 07-10-2024, 11:04 AM.

      Comment

      • CapLeaker
        Leaking Member
        • Dec 2014
        • 7972
        • Canada

        #4
        Originally posted by ivtec

        Thanks mate. It's funny that i took the back cover out and while was out tv worked fine. Also i put the Tv in my storage and today went to try to turn it on and off and so far it did not turn on by itself .
        Weird shit happens!

        Comment

        • Diah
          Badcaps Legend
          • Feb 2013
          • 6343
          • Germany

          #5
          Originally posted by CapLeaker

          Weird shit happens!
          exactly... its want retired but owner refused ...lol

          cold joint solder

          Comment

          • ivtec
            Badcaps Legend
            • Dec 2008
            • 1967
            • USA

            #6
            Originally posted by Diah

            exactly... its want retired but owner refused ...lol

            cold joint solder
            Hi mate some times it does it again, you say cold joints ,where mate in the mainboard ? https://www.shopjimmy.com/hisense-ma...for-55r6095g5/

            Comment

            • nomoresonys
              Badcaps Legend
              • Jan 2013
              • 12076
              • U.S.

              #7
              Doesn't a wonky eeprom give those symptoms also?

              Comment

              • Diah
                Badcaps Legend
                • Feb 2013
                • 6343
                • Germany

                #8
                Originally posted by ivtec

                Hi mate some times it does it again, you say cold joints ,where mate in the mainboard ? https://www.shopjimmy.com/hisense-ma...for-55r6095g5/
                dear friends,,, yours set Sony.. and yours links refer to hisense all in one boards..... your case at PSU not MB

                Comment

                • ivtec
                  Badcaps Legend
                  • Dec 2008
                  • 1967
                  • USA

                  #9
                  Sorry mates my bad;https://www.shopjimmy.com/search.php...032%20bx%20300

                  Comment

                  Related Topics

                  Collapse

                  • SluggerB
                    2 LG TV's in same room, one remote turns both on or off ...
                    by SluggerB
                    I have 2 LG TV's in a room. It seems the power button is the only IR button on the remote, since pressing the power button on either remote turns on/off both TV's. Once turned on, the remotes only work on their respective TV's (that is a setting I set on each, I gave each it's own ID)


                    I have "solved" the issue by putting electrical tape over most of the sensor on front of the TV's so they dont pick up the other remote's signal, but I was wondering of there was a more elegant electrical fix that could be done on the board of the remote and/or TV to make the remotes...
                    05-22-2022, 02:27 PM
                  • sam_sam_sam
                    Lift Master Garage Door wall switch display / motion sensor controller display disappeared no back light
                    by sam_sam_sam
                    This happened last Saturday and today I finally had time this morning before I went to work to replace two non brand capacitors

                    I will let you be the judge weather or not these are bad or not according to the blue ESR meter that I am using

                    I am comparing them to a brand new one that I installed

                    The display came back on and the programming was not lost which I was surprised by I would have thought that when the display went blank that so did the memory as well

                    I going to let it run for several days before I remount back on the wall next to the...
                    09-05-2024, 06:48 PM
                  • thetonywarren
                    Samsung un32j5205af turns on, but needs to have power disconnected to power back on
                    by thetonywarren
                    SAMSUNG UN32J5205AF

                    Wierd issue. Set turns on, works as normal, then turn off, and when you try to turn back on, it wont. The backlight comes on, but doesnt boot up. You need to disconnect power supply from back, then reconnect it, and then the set works again. somewhat annoying issue.

                    Where to start? I can provide any videos or pictures needed to troubleshoot.......
                    11-15-2022, 09:23 AM
                  • Titus6
                    LG OLE65C1 Stand-By issue
                    by Titus6
                    Hello everyone,

                    I bought an OLED65C1 refurbished TV back in 2022 from a shop. The TV is awesome, this is my first OLED and I really love it.

                    However I have an issue with the TV since the end of last year. I noticed when my TV is in Stand-By, sometimes the LED goes off then comes back on. When do so it seem periodical. It only goes away for 1-2 seconds, than comes back on. The TV NEVER turnes off, while it's on, so it's not overheating issue or electrical power issue.

                    I bought a service remote (MKJ39170828) and checked the menu 3. Power On/Off Status. I took...
                    01-31-2025, 04:01 PM
                  • NolesFan
                    sony kd-85x85j Looking for info on how to remove back cover
                    by NolesFan
                    Like the title states. TV is 3 years old and Im getting 6 red blinks, which is backing lighting issue or driver. I just cant find any info on how to remove the panel to access. Any info would be greatly appreciated.
                    03-14-2025, 08:23 PM
                  • Loading...
                  • No more items.
                  Working...