Need service manual thanks dave
Sorry that was need sevice manual e420vt burnt parts see pics
Collapse
X
-
Tags: None
-
Re: Sorry that was need sevice manual e420vt burnt parts see pics
I was just about to mention that PSU was coming up VIZIO. 102K, 1Kv are the markings on that cap C504A or C604A?
Have a look at this photo, pretty clear.http://www.shopjimmy.com/vizio-080gl...-led-board.htm -
Re: Sorry that was need sevice manual e420vt burnt parts see pics
Got it up running.. Changed 102k thanks tw2005.. But why did it burn the cap and blow the fuse? .. Running about an hour nowComment
-
Re: Sorry that was need sevice manual e420vt burnt parts see pics
The resistor probably went short and gave too much voltage to the cap, causing it to pop, and then short, and when it went short, it blew the fuse.Don't buy those $10 PSU "specials". They fail, and they have taken whole computers with them.
My computer doubles as a space heater.
Permanently Retired Systems:
RIP Advantech UNO-3072LA (2008-2021) - Decommissioned and taken out of service permanently due to lack of software support for it. Not very likely to ever be recommissioned again.
Asus Q550LF (Old main laptop, 2014-2022) - Decommissioned and stripped due to a myriad of problems, the main battery bloating being the final nail in the coffin.
Kooky and Kool Systems
- 1996 Power Macintosh 7200/120 + PC Compatibility Card - Under Restoration
- 1993 Gateway 2000 80486DX/50 - Fully Operational/WIP
- 2004 Athlon 64 Retro Gaming System - Indefinitely Parked
- Main Workstation - Fully operational!
sigpicComment
-
Re: Sorry that was need sevice manual e420vt burnt parts see pics
It is the high Voltage snubber ceramic cap for the PFC MOSFET, it is connected between the S and D pin of the MOSFET, ceramic cap fail's mode is shorted circuit., common failure in other power supply boards too.
Best to go with higher Voltage than 1KV.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809Comment
Related Topics
Collapse
-
Repair manual part number 702_58300000148618_ara_en_a
It took way too much effort to find this manual so I am sharing it here so the next person can find it easily. Also, I am mad at Bosch for not publishing it on their website, so they deserve to have it leaked....-
Channel: Schematics and Boardviews
07-14-2025, 07:36 PM -
-
by mferna14Hi Dear Friend., I am working on a Apple MacBook Pro A2338 820-02773-A. The history was that the AON Rail on the Trackpad connector JT400 was burnt. After I removed the burnt connector, I tested with the meter & no shorts. Connected the USB C power & all booted fine, no problems at all. I soldered a New TP connector put in the old trackpad with a brand new Flex cable. The laptop beeped in the start but no display. I removed the connector & the display was fine again. USED a known good Trackpad & a Flex cable, even with this still the same problem. I checked the connector whether...
-
by nobbnobb1I picked up this used Bose Acoustimass 10 IV speaker system. Speakers seem to work fine, but the subwoofer does not make any noise. So I took apart the unit and found some obviously failed (burnt) components:
- 1x 3.14 A @ 250V main circuit fuse
- 1x bridge rectifier GBU601. there's actually two of these on the board, one is obviously burnt and the other does not seem to have any anomalies like shorts. However I figure may as well replace both.
- 2x diode. This is tricky because the only markings I see on it are: "617 402". No current rating or anything else....-
Channel: Troubleshooting Audio Equipment
-
-
Postcard 32 4-Bit 4-Digit Diagnostic Card PC Analyzer Manual
Diagnostic Card is a powerful diagnostic tool for technicians and administrators to troubleshoot
various problems of IBM compatible PCs. It is easy to install, yet extremely powerful to use. With
Diagnostic Card in hand, you no longer have to go through tedious and time consuming process of
trying to figure out what is wrong with your PC hardware. Diagnostic Card will tell you exactly
what is wrong with your PC in just seconds. It saves you time and money.
Our new and improved design...-
Channel: Schematics and Boardviews
11-01-2024, 06:29 AM -
-
by spantorHello.
Some components have exploded and I can't figure out the values. I have obtained the manual for this power supply for 65" but comparing components there are some differences and it is not reliable.
Could someone leave me the power supply manual for this 55" model?
I would be very grateful03-19-2024, 01:19 PM - Loading...
- No more items.
Comment