Sharp Aquos

[lapisto]

Re: Sharp Aquos

The power board? I didn't see anything when I had it out.

Wish I hadn't messed with the main board if I had known earlier about the power failure.

[selldoor]

Re: Sharp Aquos

I am afraid your pictures are not really clear enough for troubleshooting the fo
following is what I normally advise newcomers.
Welcome to the forum-
We can help a lot more if you please post good clear pictures of the whole chassis, and then pictures of each board, front and back and close up of connectors, (max resolution 2000x2000 and 2MB) using the manage attachments button, which is found by clicking "go advanced" under quick reply.

Please do not post inline and offsite as they slow down the loading of pages.

Examples of what is needed
https://www.badcaps.net/forum/attach...1&d=1290283049

https://www.badcaps.net/forum/attach...7&d=1280167246

[lapisto]

Re: Sharp Aquos

Sorry,

I have taken new photos (this is the best I can do at the moment)

Power Board:

Front:

Back:

[psmedley]

Re: Sharp Aquos

Too grainy... looks like flash reflection too.

Best bet is to turn flash off, and get some good natural light - outside often works well....

[lapisto]

Re: Sharp Aquos

Its just the light I had on for more lighting, I can't do much better because I'm using my cell phone for the pics (but they should be better...)

If when I connect the TV back up, and Im still getting the same message, is it safe to say I haven't done more damage?

So the OPC and POWER flash twice and they are still doing the same thing, if I were to get a new power board would that get the tv back to working condition, or no there could be more?

[lapisto]

Re: Sharp Aquos

Will getting a new power supply fix all this or even then I'm lucky if that holds up for a few months?

[GT6guy]

Re: Sharp Aquos

I am not clear on your description of the error code being displayed. To make it simple, just count the blinks for each LED individually, ignoring the others. Each one represents a number. For example, 2 blinks (on) then a pause (LED OFF). So, just tell us the number of blinks for each LED.

If it is POWER LED 2, OPC LED 5, that would represent a Panel 5 volt failure.

Yes, I think you can probably fix the TV.

I have the above error code. How do I repair a Panel 5 volt failure? I have a 37" Aquos that fell off a shelf. I have repalced a broken power board and two CCFL backlights. I checked the backlights before closing up the unit and they were all working.