my friend
lenovo n500
mainboard.JIWA3 LA-4212P
REV.2.0
Intel processor
thanks
lenovo n500
mainboard.JIWA3 LA-4212P
REV.2.0
Intel processor
thanks
-
-
Re: lenovo n500 bios dump
here my friend
-
Re: lenovo n500 bios dump
hey guys, did you managed to recover your lenovo n500?
I have quite similar platform: lenovo g530 3000 with the same mobo flashed with incorrect bios rom.
tomodachi posted wph file, but it's not dump. wph also contains some service information for flasher tool....
anyway - did you recovered your bios by flashing chip using programmer either via crisis disk (or other similar disks)?
Thanks in advance,
Denys.Comment
-
Re: lenovo n500 bios dump
backup old bios and try this
Compal JIWA3 LA-4212PIm Back... sort of...Comment
-
Re: lenovo n500 bios dump
Hi Guys,
Thanks for the files, but I've already disassembled the laptop, soldered out flash and connected it to a Sivava Programmer (Willem) and programmed a correct bin from lenovo off site...
This is the only thing worked for me.
Trying to recover with Crisis disk (lots of various combination) - failed.
Cheers,
Denys.Comment
-
Re: lenovo n500 bios dump
BTW, I have JIWA4 mobo..Comment
-
Re: lenovo n500 bios dump
Hi! I have lenovo g530 (JIWA3 LA-4212P REV.2.0). After putting damaged ribbon cable for display (I didn't see that flat is damaged in first place) laptop keeps turning off. Just turn on led lights and cooler for few seconds, and turn off. I found that IC power chip (at least I think that is IC power chip) for that few sec was extremly hot. Mark of that chip is 'ene kb926qf -d3'. I think that must change. I need to know is cause or consequence? I hop you'll understand me and answer me Thanks
Comment
-
Re: lenovo n500 bios dump
ThanksComment
-
Re: lenovo n500 bios dump
thank uComment
-
Re: lenovo n500 bios dump
ThanksComment
-
Re: lenovo n500 bios dump
ThanksComment
-
Re: lenovo n500 bios dump
ThanksComment
-
Re: lenovo n500 bios dump
thanksComment
-
Hello all,
I have a Lenovo Thinkstation P500 that is stuck at post with no display, it happened after I changed the memory timings in bios. I can not clear CMOS using the jumper on the motherboard, also tried re-flashing bios suing a USB stick but it also doesn't work. The only solution that I can think of right now is re-flashing the bios chip using an external programmer but the problem is that I don't have the bios dump of p500 for flashing externally and I don't know the location of bios chip. If someone can provide the bios dump and bios chip location it would be really helpful.... -
Hi all,
This is my first post here (I am very new to forums!) and I hope someone can help. I am looking for a full dump of the BIOS of a HP Proliant Microserver Gen 8 so that I can get this mini server running again. (BIOS version J06 2019-04-04, chip 25Q064A). I think my board was partially bricked after a failed BIOS update.
I got it second hand in this state and all the normal attempts at bios restoration have not worked. I have even desoldered the chip and tried to load the actual BIOS from HP, but it is missing some parts needed to boot the system.
I... -
Hi everyone,
Iām looking for a 2 MB BIOS dump for a Lenovo IdeaPad 5 16ARH7H / Legion 5 with mainboard NM-E471 Rev. 2.0.
The BIOS chip is a Winbond W25Q16FW (1.8V, 2MB) and it's completely unresponsive / bricked. I tried recovery via USB but no success. Now I want to reflash it externally using a CH341A programmer.
I already found 32MB dumps (e.g. from Vinafix and Badcaps), but they are too large for the chip ā and the last 2MB in those files are just FF FF FF....
ā What I need:- A working 2MB BIOS dump
- Matching NM-E471 Rev. 2.0, e.g. JY575
-
Dear all,
I have a ASUS ZenBook UX480F with the following symptoms:
I suspect it is a BIOS issue. So I decided to try to clean the ME region. I followed the guide on win-raid, and I believe I have done everything correctly. My problem is: when I open the outimage.bin in ME Analyzer, it says that it is Extracted, and not Region, Extracted as it should be. Is it normal, or did I do something not correctly? This is my first experience editing BIOS files.
I would appreciate if someone could take time to explain the issue, so that I can learn. But I would... -
The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
...
Comment