Hello brothers and sisters! Did a few repairs on the board and it turned on recently then it died. We threw it in the Ultra Sonic cleaner (previous water damage board) then it turned on. After a day or two it seems it completely shut off and wont boot.
I get a reading on the USB Tester at:
20.3V
0.28A rises to 0.89A then to 1.13A then resets back to 0.03 Amps and repeats the cycle. The board gets hot on the left side but the GPU seems to not have any heat, we are assuming the GPU may have a bad cap. It appears to be no Board Views for this board online so we are going off of what we see.
Side note: Replaced the battery with another OEM (new battery) and replaced the battery cable connector as well. So two new components. Before the other component (cable) would only let the computer get to 20.0V and only go to 0.28A and no more. After replacing the cable it cycles up to 1.13A. Any suggestions? Also we are going to be broadcasting live with this board soon when all the equipment comes in
I get a reading on the USB Tester at:
20.3V
0.28A rises to 0.89A then to 1.13A then resets back to 0.03 Amps and repeats the cycle. The board gets hot on the left side but the GPU seems to not have any heat, we are assuming the GPU may have a bad cap. It appears to be no Board Views for this board online so we are going off of what we see.
Side note: Replaced the battery with another OEM (new battery) and replaced the battery cable connector as well. So two new components. Before the other component (cable) would only let the computer get to 20.0V and only go to 0.28A and no more. After replacing the cable it cycles up to 1.13A. Any suggestions? Also we are going to be broadcasting live with this board soon when all the equipment comes in
Comment